Gunsmithing badger bottom metal
- Thread starter azfred
- Start date
Re: badger bottom metal
The ultra mags won't fit into the magazine without modification to the mag.
The ultra mags won't fit into the magazine without modification to the mag.
Re: badger bottom metal
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: azfred</div><div class="ubbcode-body">Will the badger detachable mag bottom metal for 338 lapua also feed 338 ultra mag? </div></div>
Yes but, it will require a short COAL. Look at the Seekins instead for the 338 Edge / RUM
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: azfred</div><div class="ubbcode-body">Will the badger detachable mag bottom metal for 338 lapua also feed 338 ultra mag? </div></div>
Yes but, it will require a short COAL. Look at the Seekins instead for the 338 Edge / RUM
Re: badger bottom metal
Also consider the Badger Ordnance CIP length DBM:
The AICS 338 LM CIP mags buy you another about tenth of an inch:
Badger lists them as 3.75", the standard 338 AICS run cartridges to about 3.650ish coal.
We have milled the front reinforcing rib off the 338 mags and had good success running them for ultramags.
Also consider the Badger Ordnance CIP length DBM:
The AICS 338 LM CIP mags buy you another about tenth of an inch:
Badger lists them as 3.75", the standard 338 AICS run cartridges to about 3.650ish coal.
We have milled the front reinforcing rib off the 338 mags and had good success running them for ultramags.
Similar threads
