Latest activity Postings Featured content Achievements About Feedback Stats
-
-
ShtrRdy replied to the thread Easiest Chassis to Install Barreled Action Into.If it's an older 591, no problem. If there is a newer 591, maybe. I believe the older AICS had some interference with a Jewell... -
ShtrRdy reacted to AustinCar32's post in the thread Match grade barrel fouling after 40rds? with
Wow.
I used to live near Forest Grove, its gone downhill in recent years with the homeless. Now im between Scappoose and Vernonia. Scappoose... -
ShtrRdy replied to the thread Easiest Chassis to Install Barreled Action Into.It's generaly very easy. A couple things that would need gunsmith attention is if the recoil lug is thicker than the cutout in the...
-
ShtrRdy reacted to hafejd30's post in the thread Easiest Chassis to Install Barreled Action Into with Like.
Just about any of them with a modern chassis will be good to go. MDT/MPA etc
-
Contacted proof, they sent me a RMA pulling it off and sending it back in the morning. Hopefully this issue is a simple fix.
-
Yeah. 60º action etc lol I shoulda shut up when I was ahead; see below
-
ShtrRdy reacted to supercorndogs's post in the thread Any Old Remington Employees Here, or Smiths Experienced On the Remington 700? with Like.
The mag box being tight would mean when tightening the action screws, it would make the action flex in the middle.
-
ShtrRdy reacted to spife7980's post in the thread Any Old Remington Employees Here, or Smiths Experienced On the Remington 700? with Like.
If the mag box doesn’t have play then it’s putting stress between the stock and the action. It should be free to wiggle, but not flip...
-
ShtrRdy reacted to MouthMechanic's post in the thread Accessories New in the box ACC Elite and Rubber Dampers with Love.
New still in the box Black ACC Elite and new in individual box rubber dampers also inside. For 700 SA $1525 shipped and insured or...
-
I bought this here a couple months ago and have decided not to use it for now Matrix pro 2 - SA R700 ambidextrous in gunmetal gray...
-
I say leave well enough alone and don't worry about the 0.004" headspace with the previously fired and acquired cases . When You can...
-
So I did end up swapping scope’s yesterday and shot a good group in the .3s right from the get go so though maybe that way the issue so...
-
ShtrRdy reacted to uppercut11's post in the thread Advice Please - Accuracy showed promise but fell apart on custom 7 mm PRC with Love.
I am extremely happy to report back that my issues have all been resolved thanks 100% to Shawn Boggeman at Triggered Precision Machine...
-
ShtrRdy replied to the thread Advice Please - Accuracy showed promise but fell apart on custom 7 mm PRC.Sounds like you had some excellent service from these two companies. I can second the recommendation for Shawn Boggeman at Triggered...
-
With 42gn of 4350 I’m at 2830fps no pressure signs and my SD is a 3 but not shooting well. I feel like anything 2800+ is asking a lot of...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
