Recent content by BClrh

  1. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Mine kept loosening off to so I lock tited them. I might have to see if I can modify them to not rotate.
  2. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    The flush cups on the butt stock of the DT's are the rotating type, is there a good option to switch to something non-rotating?
  3. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    I was thinking of doing something like that. If you could fill the gap behind the lugs it would be locked in. Have you done this before? What compound would you use? I would think it would have to be something that isn't very runny.
  4. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Thanks guys, I will make sure the rail isn't to narrow.
  5. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Has anyone had an issue with there scope mount moving on there rail? I have a NX8 4-32 in a NF uni-mount and I could see a bit of a rub mark in the ceracote on the rail so I checked the torque on my rail and it was good. I then backed off the cross bolts and the scope was against the rear of...
  6. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    That is some good shooting with a lapua. What velocity are you getting?
  7. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    I bought a srs a2 covert and two conversions from sac and imported them with profit river and it was no problem
  8. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    At the moment they are non restricted and will be good to go for hunting.
  9. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    My coal with 75gr eldm's is 2.415 and I was supposed to have the long range chamber. That puts the bullet pretty deep in the case.:(
  10. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Do you know what your coal is with the 75gr eldm touching the lands? What kind of jump have you had success with? I am supposed to have the long range chamber in mine but the 75gr eldm seems to be seated pretty deep in the case at the lands.
  11. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Yeah there illegal. It sucks. Worst that would happen is 20 years in prison.
  12. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    I was keeping an eye on that and there wasn't any for the first 20 rounds or so. I haven't checked it after my last couple range trips, but I will take a look. It is a side port brake as well so that would help.
  13. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Yep, 18"
  14. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Ran a ladder test with H1000 and 230 Atips in the 300NM. Went from 80gr to 85.6gr in .4gr increments. Velocity went from 2550fps to 2745fps. There was a faint ejector mark at 85.6 but felt nothing on bolt lift or extraction. I don't think I will run any higher than that. Lapua brass can take...
  15. B

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Have you seen the SAC one? If it is the one I remember it is shaped like a traditional rifles recoil pad.
See more
Top Bottom
Back
Home
Forums
Merch
Alerts