Recent content by BobinNC

  1. BobinNC

    Berry tumbler question and fine grit stuck in flash hole

    I have a Berry Tumbler and I use Rice: Play With Your Food: Clean Brass With Rice And this is the rice I use: Nishiki Premium Rice, Medium Grain,15 Pound
  2. BobinNC

    Aadland cap question...

    I can't confirm that they will fit, but Aadland doesn't like to waste space. Hence he has separate listing for the Viper PST 1-6x24 and the Razor 1-6x24. I just bought scope covers from him, for my Credo 1-6x24 and they were listed together with the Credo 1-4x24, as one listing. Look that may...
  3. BobinNC

    What's the Go-To 223 Brass Now?

    RUAG International: Is a Swiss multinational defense company that was the parent company of RUAG Ammotec. RUAG Ammotec: Was the ammunition and components manufacturing arm of RUAG International, with brands like RWS, Rottweil, GECO, and Norma. Beretta Holding: In August 2022, Beretta...
  4. BobinNC

    Reloading Setup finally finished.

    Your setup looks good, but your location in the garage leaves much to be desired, unless it has it's own climate controls. I tried reloading in a garage once. It was unbearably hot in August, froze you nuts in off in January, and powder once opened was affected by the uncontrolled humidity...
  5. BobinNC

    What's the Go-To 223 Brass Now?

    I use Starline 5.56mm Brass with complete satisfaction. It is currently in stock. #3440 - 5.56x45mm Brass (Small Rifle primer) Years ago Starline brass was much heavier than say LC brass by several grains, and care had to be taken when swapping known safe LC loads into Starline 5.56 brass...
  6. BobinNC

    A Small Rant about AR mounts ahead of April Fools Day

    So I just bought a nice Trijicon Credo 1-6x24 FFP Mil Red, all of 19 oz of it. And I got it for a steal of a deal. That aside, I knew I need some new 1 piece mounts that didn't weigh a ton, so I let my fingers do the walking in the digital marketplace. And while shopping my angst was aroused...
  7. BobinNC

    Powder Dispensing Accuracy & Match Dies

    I've gotten my best performance from mix and match Reloading Dies: Lee Collet Dies for Neck Sizing Redding Body Die for full length sizing of the case below the shoulder, but not size the neck at all. In Micrometer Seating Dies, I like the RCBS Matchmaster seating die or the Forster Micrometer...
  8. BobinNC

    Upside down reloading tray.

  9. BobinNC

    Upside down reloading tray.

    Buy two 50 round aluminum trays for less than $60. and now you have a place for 100rds. 6.5mm Creedmoor Ammo Reloading Block Solid Aluminum 50 rounds Fabrication Warehouse I've bought many aluminum trays from this vendor in a variety of case sizes. Remember a fool and his money are soon...
  10. BobinNC

    Upside down reloading tray.

    $94.99 is pretty pricey for a "reloading tray". But it is Marine veteran made so it will last "forever" or just mere minutes if a Marine Grunt Lance Corporal gets ahold of it....YMMV
  11. BobinNC

    Rosco barrel accuracy expectations/problems

    And I just ordered a Roscoe 16" K9 Barrel & Hatchet to replace my Gov'ment contour 16" SS Aero barrel that is a poor shooter.
  12. BobinNC

    Upside down reloading tray.

    OK, buy a MTM Case-Gard RS-S-50 for around $6.00. Cut the top off, and presto you now have a 50 round reloading tray that will hold 6.5 Creed and .308 Winny rounds case down, and still let you pluck them out by the rims. Do not buy the one made for the 308 or 6.5 Creed as they set an upside...
  13. BobinNC

    What Vises Are You Using (Barrel or otherwise)

    I use an Columbian #4 Vice. I have rubber jaws inserts for gunsmithing work. I have a variety of vise jigs for AR work
  14. BobinNC

    Rifle Scopes Xtr pro… red vs black

    Yup, buy the red if you want one.......
  15. BobinNC

    Rifle Scopes Xtr pro… red vs black

    Where are you finding that price difference?? I'm not searching the web to find the best price on either, as I don't want one, but: The MSRP's of 202212 & 20222 are exactly the same from Burris, so it must be a supply and demand thingee. I guess nobody likes the Red. Go figure.... Burris XTR Pro
See more
Top Bottom
Back
Home
Forums
Merch
Alerts