Recent content by ci11

  1. C

    SOLD J. Allen RH 700 Chassis

    BAT changed the position of the posts around SN 1050. Was Joe's VR lower or higher than 1050?
  2. C

    WTB AICS AX 2.0 700SA in black - NIB / LNIB

    Looking for AICS AX Mk 2 with 13" foreend for 700SA in black, product code 26712BL or 26712EM. Must be New In Box or Like New In Box, complete with all original factory-supplied parts.
  3. C

    Accessories SOLD Foundation Exodus Stock for impact/Hawkins $825

    Is the Impact action Rem 700 SA compatible?
  4. C

    Optics SOLD Schmidt & Bender PM II 5-25x56 P4 Fine Illuminated MIL DT cm ccw NIB

    SOLD to 2tuf4u - thanks!
  5. C

    Optics SOLD Schmidt & Bender PM II 5-25x56 P4 Fine Illuminated MIL DT cm ccw NIB

    Thank you!
  6. C

    Optics SOLD Schmidt & Bender PM II 5-25x56 P4 Fine Illuminated MIL DT cm ccw NIB

    Great catch - thank you - a slip for sure. Listing is edited and is now correct.
  7. C

    Optics SOLD Schmidt & Bender PM II 5-25x56 P4 Fine Illuminated MIL DT cm ccw NIB

    Reticle - P4 Fine reticle illuminated Turrets - MIL double turn, counter-clockwise This scope is brand new and has never been mounted or used. its optics, coatings are pristine and mechanicals positive. It comes in the original factory box with the manual and hex key. Front and rear Butler...
  8. C

    Optics FOUND: Leupold RX-2800 TBR/W Laser Rangefinder

    PM Sent
  9. C

    Optics Nikon Black RangeX 4K range finder ~Sold~

    still confirming some details.....
  10. C

    Accessories Figured Walnut stock blank

    what are its dimensions?
  11. C

    New GAP Extreme Hunter in 6.5 SAUM

    Pat, I remembered you switched from Tula LRM to GM210M recently. Do the 210M (and 215M) fit the notoriously "generous" Rem primer pocket better than the Tula? What are the actual performance differences between these primers for the 6.5 GAP round, and what would be good alternatives as all three...
  12. C

    New GAP Extreme Hunter in 6.5 SAUM

    Not sure if what I can share can be called "advice" but here is what I have been able to gather: 1. The Armalite factory 300 SAUM "AR-10 (T) Ultra" uses proprietary parts made for the specific requirements of the AMU trials. Armalite will not sell these parts to anyone except owners who broke...
  13. C

    New GAP Extreme Hunter in 6.5 SAUM

    Please see attached chart. 2 series are shown with different COAL and Twist. Also added powder type and percent of powder burnt to second series. With the longer COAL and slower twist, 2 MV's stayed the same (but all used more powder). RL25 and Retumbo burning 100% of powder will probably leave...
  14. C

    New GAP Extreme Hunter in 6.5 SAUM

    Attached is a table showing some QL runs with the powders you named above. They are based on the following assumptions: 1. 24 in tube 2. 130 VLD Hunting Pointed, BC assumed to be 0.600 3. COAL 2.825 4. Case H2O 73gr 5. Pressure as close to 55kpsi without going over Sorry - did not know...
  15. C

    New GAP Extreme Hunter in 6.5 SAUM

    How about Ramshot Magnum, Accurate Magpro and IMR 7828SSC? They are all slower than 4831SC.
See more
Top Bottom
Back
Home
Forums
Merch
Alerts