Recent content by DirtyDirty130

  1. DirtyDirty130

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Ok guys, im struggling with feeding .223 55gn. Soft points in my SRS A-1 I bought the .223 kit from SAC but chambered the barrel on my lathe. the rounds are popping out of the mag before the round enters the chamber. Its better if i feed it fast and hard but even then its 50/50. Im wondering if...
  2. DirtyDirty130

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Hey guys, i picked up this .300wm bolt off the Hide a while ago and im getting ready to spin up a barrel for it. It looks like this bolt has been reworked after it was finished and im wondering if the massive chamfer on the firing pin hole is going to be an issue. Any thoughts?
  3. DirtyDirty130

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Im in Amherst VA and have a covert with a 18” 6.5CM
  4. DirtyDirty130

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Thanks, i just sent him a PM
  5. DirtyDirty130

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    im looking for molly pouches for storing srs mags in my riffle case. Does anyone know what would be a good option?
  6. DirtyDirty130

    SOLD Armegeddon Gear Precision Rifle Sling FDE

    I will take this if its still available
  7. DirtyDirty130

    SOLD Steiner Throw-lever

    Thanksgiving bump
  8. DirtyDirty130

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    My son shot his first deer today with the 6.5CM!! Dropped him in his tracks.
  9. DirtyDirty130

    SOLD Steiner Throw-lever

    Looking for a aluminum Steiner brand throw lever for a t5xi or p4xi
  10. DirtyDirty130

    Official (DTA) SRS, HTI, Covert, Hunter Thread

    Anything lower than 1.5” is going to be too low to get good cheek position. I have a 1.67” ARC mount and the cheek riser is in the middle position.
  11. DirtyDirty130

    SOLD WTS - vortex radian leveling tripod

    Seconds if it falls through