-
Having trouble using the site?
Post any issues in the thread below or reach out directly to support!
Contact support
Dolomite's latest activity
-
DDolomite replied to the thread Full length sizing after that stretch!.Dumb question but are you zeroing out the calibers after each measurement? If yes stop you are bumping the shoulder way too much...
-
DDolomite reacted to stello1001's post in the thread Full length sizing after that stretch! with
Like.
When you zeroed on a once fired brass that had not been sized, was your spent primer still in the case? If so, it is possible your... -
DDolomite replied to the thread Full length sizing after that stretch!.You mean the CBTO is not changing as you screw in the die? Post some pictures of die in the press. And the die and lock ring.
-
DHow did you determine they expanded that much? I have a hard time believeing they stayed in one piece.
-
DSMK 80 is my second favourite 224 bullet for a long throat 223 Rem match. The BC isn’t as sexy as the 80 ELD-M or the Berger 80.5 but...
-
DDolomite reacted to Bmghunter's post in the thread How much do I need to pay for my friend? with Haha.
Given you most likely will end up upgrading many of the items, I think he cost you more money 😝
-
DDolomite reacted to AllenOne1's post in the thread Forster FL sizing die, brass wouldn't go in with Like.
I had the same issue the OP is having with a 6.5C die. I ended up sending it back to Forster (their customer service is very good) for...
-
DDolomite reacted to spife7980's post in the thread Forster FL sizing die, brass wouldn't go in with Like.
I agree with dolomite, get some measurements and assign actual numbers to the issue instead of just guessing.
-
DDolomite reacted to ma smith's post in the thread Forster FL sizing die, brass wouldn't go in with Like.
the fact this thread has zero measurements is a red flag... resizing is all about taking the brass from point a to point b...
-
DDolomite replied to the thread Forster FL sizing die, brass wouldn't go in.Forster FL dies sizes the case almost back down to factory size if not smaller. Measure base & should neck junction before and after...
-
DDolomite reacted to alamo5000's post in the thread Forster FL sizing die, brass wouldn't go in with Like.
Have you inspected the inside of the die? Too much lube can be a problem so try cleaning the inside of the die out really good with some...
-
DThe carbon left inside the neck will still develop an abrasive oxidation layer when annealed. To mitigate that abrasiveness, lube can...
-
DDolomite replied to the thread Dark necks on annealed cases.I don’t have any technical data but I anneal and have both the faint blue line and dark necks.
-
DDolomite replied to the thread Determining annealing duration.reduce the flame some so the inner blue flame tip is hitting the neck. That should get it hotter quicker.
-
DInitially I thought you were kidding, but with the timestamps you provided, I think you might be right. I'll show the video in person to...