Recent content by j-dubya

  1. j-dubya

    DD M4A1 RIII vs LWRC DI vs Geissele Super Duty

    Jake, who makes that little bag rider add-on for the CTR?
  2. j-dubya

    Hodge Defense In Review

    318 was about like Rudy described his A1 stuff. Firing 10-shot groups, 7 out of the ten would be 1” to 1-1/2”, and then there would be three rounds that would kick the group out to 3”. Happened every time. I stuck with 77gr.
  3. j-dubya

    OBR 7.62 and non-Larue Suppressors

    Mine ran fine with a standard Colt rifle spring and H2 buffer with the 1st gen Surefire RC suppressor. This was a ‘09-10 OBR - pre-xtraction Lothar Walter barrel.
  4. j-dubya

    New Labradar LX

    Came to post about that as well. It must have been a suppressed shot too...
  5. j-dubya

    Centurion Arms MK12 barrels

    Any idea on who he is using for hammer forged barrels now?
  6. j-dubya

    6 ARC - Anyone Regret It? Also considering 22 ARC

    Has the magazine situation stabilized as to what is reliable and what has shown to have any issues? I haven’t been active on here in a couple of years, but back then when 6arc was just getting going, a member here turned me on to the e-lander mags as they were the best at the time. This...
  7. j-dubya

    What is loaded in military 7.62 M118LR

    And in that very same article: “The Mk316 ammo is in the process of replacing the original M118LR ammo but it is unknown how long a full replacement will take,” Two different ammunition products. Go to an ASP with a request for AB39 and see if they bring you anything with AA11 on the box, or...
  8. j-dubya

    What is loaded in military 7.62 M118LR

    Nope. While they use the same projectile, they are two different ammunition products. Easiest proof is two DODICs. Brass, primer, and powder have always been different from each other, and AB39 came into supply existence to alleviate some issues with AA11 (temperature). FGMM (308) and the...
  9. j-dubya

    What is loaded in military 7.62 M118LR

    That’s not m118LR, but the mk316, DODIC ab39, aka Federal Gold Medal Match 7.62x51 (not the 308). M118lr’s DODIC is AA11. Those two are constantly confused with each other here. OP, powder from that timeframe was Reloder 15.
  10. j-dubya

    MK11 MOD 0 Build

    The blocks have cosmetic differences between the two. The m110 block has the center of the lower rail cut out like your photo above, along with the two horizontal scallops cut out between the gas tube and barrel on each side. A mk11 block is all solid and filled in in these areas. Only other...
  11. j-dubya

    Thinnest mlok pic rail?

    Arisaka.
  12. j-dubya

    TMK’s For Field Use? Match/Deployment...

    Thanks. Good to hear. The 77’s in 5.56 AR is what I’m mainly interested in. Still not sure I’d put them in a 308 gas gun yet.
  13. j-dubya

    SPR/DMR matches: What are you running?

    For the guys talking about the void, particularly in the Southeast... where are you guys located here in the SE? Perhaps there’s enough of us to pool resources and begin to fill that void...? I am in the northwest Atlanta area, and have the ability to clear land and move earth...
  14. j-dubya

    TMK’s For Field Use? Match/Deployment...

    Asking here since it’s more platform related instead of ammo. Specifically the Sierra tipped projectiles, are they reliable enough for field use in gas guns? Would you trust them enough to deploy with, or use in a high-stakes match? I have always been leery of them after having Amax’s years...
  15. j-dubya

    Hammer Forged Chamber...?

    I had started a thread a couple of years ago with a similar question, only it was based more on gas port erosion. The thread didn’t seem to take off, aside from being at the same time as when Bartlein’s new material was coming out. But the subject is still interesting to me, and may be a bit...
See more
Top Bottom
Back
Home
Forums
Merch
Alerts