Recent content by JMcBurn

  1. J

    Reloading Equipment WTB: 6mm GT Dies

    Purchased. If you get any more sets of the hornady dies (would prefer the bushing ones), let me know.
  2. J

    Reloading Equipment WTB: 6mm GT Dies

    Looking for a set or 2 of preferably Hornady dies.
  3. J

    RRS Anvil 30 for Binos?

    If people are concerned with the idea of running just the anvil 30 because it gets rid of the best part of a standard ball head (the panning feature). You can buy panning bases and attach the the bino mount to the panning base (can get them with a built in arca plate bottom). Many companies make...
  4. J

    CZ 457

    Shawn, Take a look at the m&p 15-22 mags, they have a button and only need a mag well adapter.
  5. J

    Off-brand ARCA Plates?

    Those plates have been used in videography rigs for a while.
  6. J

    Pre fit barrels vs gunshop barrel fitting

    I know it is anecdotal evidence, but I know my smith does that and comparing to my friends prefits, they don't seem to be a easy to tune a load for when I was helping him do load dev. I am talking about in terms of more vertical deviation when running a ladder of powder charges. Also it helps...
  7. J

    CZ 457

    Just went and shot my MTR after picking it up from Area419. Bolt close is a bit harder that I would like, but it engraves really well with my Aguila Super Extra Std Vel and some CCI Std Vel. Both shot about .5" at 50yrds. I think this rifle is gonna treat me well. Gonna put a trigger spring from...
  8. J

    Gunsmithing 6dasher to 6GT

    The end of the throat is ~0.200" farther down the bore than a standard dasher reamer.
  9. J

    Gunsmithing 6dasher to 6GT

    George designed the case so it could clean up a dasher chamber.
  10. J

    Bergara 22lr magazine pic

    Well I just bought a CZ457. Haven't even received it yet. Just my luck.
  11. J

    CZ 457

    You think there is is room for a 0.156" diameter spring/have you bought a dozen of them from mcmaster already?
  12. J

    Suppressors QuietBore 22LR Titanium Suppressor Build Review -***Approved Form 1 Required***

    So just asking the question, any reason to not grab the 22lr can with aluminum internals? If only for the ease of drilling/cost savings?
  13. J

    Suppressors Can I put my baffles in a tumbler to clean?

    The tube on his suppressor according to the manufacturers website is aluminum and all the baffles are 17-4 PH, so I definitely wouldnt be afraid to tumble them.
  14. J

    Suppressors Can I put my baffles in a tumbler to clean?

    Why couldn't you?
  15. J

    Attention 22LR Rimfire shooters - See this

    Just bought a 457 MTR as my first rimfire that wasn't a squirrel gun. Would love to try some decent ammo to talk myself into buying it more steadily.
See more
Top Bottom
Back
Home
Forums
Merch
Alerts