Recent content by Notdylan
-
N
Who has built a "do it all" rifle?
What did you build and has it met your expectations? I'd like something accurate to 1200 yards that I could shoot in local prs type matches but ideally be around 10-11 pounds fully equipped for hunting. I know a lot of people have attempted to do it...- Thread
-
N
Rimfire SOLD Vudoo 22
16.5 Vudoo in a MPA Competition chassis, factory Vudoo barrel, and Calvin elite 2 stage trigger. Rifle is just at one year old with ~650 rounds through it. Chassis has some use on it as seen in pictures but the action and barrel are pretty clean. Chassis comes with shown accessories (also...- Notdylan
- Thread
- Replies: 11
- Forum: Buy - Sell - Trade
-
N
Firearms WTS: Zenith Z-5RS
Used Z-5RS with approximately 200 rounds through it, in great shape. This one had a wobbly magwell and some finish issues from MKE but went back to Zenith and is now finished great and the magwell is good and snug. Comes with everything pictured including the factory optic mount which is not...- Notdylan
- Thread
- Replies: 2
- Forum: Buy - Sell - Trade
-
N
Cost effective/Complimentary Caliber?
So I've got a 6mm Creedmoor and I'm looking to build another rifle with the same action/stock to compliment it. I'm looking for complimentary caliber, something that is easy to load for and affordable to shoot. I want a good balance of barrel cost...- Thread
-
N
Gunsmithing Bedding/Action fitment questions
The receiver will drop lower and sit flush with the inlet, that is just showing the amount of slop that is present with the action screws fully tightened. The more I look at the DBM inlet, it does appear to be a close match to the Badger unit, which is not cheap. I was hoping to not invest too...- Notdylan
- Post #7
- Forum: The Armory
-
N
Gunsmithing Bedding/Action fitment questions
Could be! Looks like the badger dbm kit comes with bedding pillars but the stock already has some installed. I wonder if they are the same? Not sure what to do here.- Notdylan
- Post #5
- Forum: The Armory
-
N
Gunsmithing Bedding/Action fitment questions
Definitely a possibility and something I have wondered about. I'm not 100% certain of the origin of the stock, it was sent to my employer as a sample, that's all I know.- Notdylan
- Post #3
- Forum: The Armory
-
N
Gunsmithing Bedding/Action fitment questions
I was gifted a Manners stock inletted for a Remington Model 7 and I just so happen to have a rusty Model 7 laying around. When I put the action into the stock, there is maybe a 1/16" of play with the action screws tightened down. Will bedding take care of this? Is it common to need to create...- Notdylan
- Thread
- Replies: 6
- Forum: The Armory
-
N
Rifle Scopes ATACR 4-16 Mil R or Mil C Reticle
I've had both. Mil-C hands down.- Notdylan
- Post #2
- Forum: Observation & Sighting Devices
