Rob01's latest activity
-
Rob01 replied to the thread Suggestions for starter Chassis bolt action rifle in 6.5?.And that PVA deal is even a better one if you didn’t like the chassis in the completed rifle. Then you add the trigger and chassis you want. -
Rob01 replied to the thread Suggestions for starter Chassis bolt action rifle in 6.5?.Don’t be short sighted and buy a cheap factory rifle for a few hundred less than the rifle you can get that FuhQ posted. You will be...
-
Drop tested mine earlier. 16lb 300winmag standing muzzle down with a barrel full of boretech. Got knocked over and flipped around just...
-
Ok, so long as it's the same headstamp, the same load will generally be fine without having to do new development all over again? Got...
-
I am the exact same way. Several lots just keep track of firing.
-
New DNT came in yesterday, but the weather was shit today (freezing, snow in some parts, rain, winter storm, etc...), so I haven't taken...
-
Rob01 reacted to FuhQ's post in the thread Is it ok to use vibra-tite vc-3 for both side of the barrel? with
Like.
That's why I use and recommend just using some TW25B or Aeroshell 64/33MS. 👍🏼 -
Rob01 replied to the thread Is it ok to use vibra-tite vc-3 for both side of the barrel?.But again remember neither is needed and a little grease will work fine. Grease also cleans easier. Anti seize can be a mess.
-
Rob01 replied to the thread .308 mtu or m24?.Yeah if you are humping through the snow and mountains I would doubt you would have either of the discussed contours. If he wanted a...
-
Rob01 replied to the thread .308 mtu or m24?.Not in my rifles. I don’t add anything to the rear and usually some to front.
-
Rob01 replied to the thread 6.5 Creedmoor.Oh yeah they are all different lots over different years. I don’t separate them by that though. Just by firings. No problem using the...
-
Rob01 replied to the thread 6.5 Creedmoor.I have a little different situation than some as I have thousands of pieces from factory ammo so I don’t go through firings as much as...
-
Rob01 replied to the thread 6.5 Creedmoor.You can without problem. I used those dies for years from 2008 when they were the only ones made. Very accurate ammo and good es/sd...
-
Rob01 replied to the thread .308 mtu or m24?.Definitely not a straight. Lol That’s a Bartlein barrel. I have some PVA Osprey proof Comp Contour barrels that are heavier than that...
-
Rob01 replied to the thread .308 mtu or m24?.It should be if you are running the rifle right and have it set up correctly. I have a 28” M24 on my .308 and 6.5 Creedmoor now. The MTU...
-
