Man! This is really cool! Very nice! No idea they had these. Should’ve figured with the “Right Arm of the Free World” right there with it. GLWS. Thanks for sharing.
Lol. No plans to face it off at all. Not even a clean up cut. My gauge pins don’t go up much past .270 I believe and that was for a locking shoulder on an FAL to set headspace. The Y/M was
OOS on their website. Thank you for your help!
Good morning,
I’m going to turn down the back side of a no go gauge to fit an ar10 bolt face. Would anyone be able to give me the ID from one side of the wall to the outside of the ejector? Thanks!
bumping an older thread. @strikeeagle1 would you happen to have a dimension if I were to turn a 308/6.5cm gage down to where no disassembly of the bolt is required? I got gages and access to machines but not disassembly tool.
Edit: I THINK about .323 may do it? Call it 5/16 to be safe?