1 Stage or 2 Stage Trigger for PRS22

HartBurn

Private
Minuteman
Apr 23, 2020
11
1
Arkansas
I’ve never ran an upgraded trigger on CF or RF but I’d like to buy once, cry once if possible. I plan on competing eventually but I’m unsure on whether single or double stage is more widely used for PRS22. Quite frankly, I’m not very knowledgeable about them so I’m not afraid to look stupid. If you set both stages to 14oz does it essentially become a single stage 14oz?? Educate me.
 
No, if you set both stages to 14 oz it'll take 28 oz of total pressure to break a shot. However, our brains tend to interpret it more like a single 14-16 oz break; the brain "forgets" the 14oz you're holding to get to the wall.

I'm sure you can find videos explaining this, so I'll only answer the other question you had about prevalence. Single stage triggers are more prevalent, but there are a decent proportion of people running a 2-stage, myself included. People have different preferences for different reasons, but the reasons I like a 2-stage:
- Taking up the first stage is how I "drop in" mentally for that shot; it basically begins my firing sequence, and I can always back off
- It makes an ND (negligent discharge, usually a stage or match disqualification) less likely, esp wearing gloves (note here: lots of folks will say "You just need better trigger control," and maybe they're right, I don't much care)

I've tried both, and discovered I prefer the 2-stage; I think for most people, you just need to try both for a while each and see what you like better. Because the trigger is one of the most critical interfaces you have with the rifle, I think it's worth buying twice and crying twice, if that's what it takes to get a fit that's right for you. You can always buy used and sell the one you don't want.

Good luck!
 
Last edited:
I run 2 stage triggers in nearly every rifle I shoot. My RF triggers are Anschutz (no reason to upgrade them). My AR triggers are 2 stage trigger tech, my Impact actions now wear Bix n Andi TacSport ProX 2 stage. My preferred settings are 4-5 oz 1st stage and 6-10 oz second stage. You add them up to arrive at your final weight of 10-15 Oz.
 
  • Like
Reactions: 308pirate
I have always run a single stage trigger, and I stick with it because it’s what I’m used to. The posts above are very valid reasons to run a two stage. If you go the CZ route, it will be a single stage Timney. Mine came out of the box at 12 oz, so I didn’t touch a thing on it and installed it.
 
  • Like
Reactions: oldrifleman
All my centerfire and rimfire rifles have single stage triggers. I like single stage because when I press the trigger I want it to go off. I don't want take up. Never liked two stage. Try both and see what you like and use it.
Exactly, while I have trained and practiced with a 2 stage that does not mean anyone else will feel the same way or have settings like mine.
This a very personal decision and it requires practice to master what ever you pick.
 
I shot two stage triggers for a season a couple of years ago and looking back at that season my match scores dropped off, when I switched back to single stage the following season my match scores went back up.
I personally prefer a Tiggertech Diamond flat shoe set at 12oz and don't think light triggers are a good Idea when shooting off props I don't care if they are two stage or single I've seen to many ND's over the years.

As someone said above try both and decide which is better for you, don't buy a two stage because that's what everyone else is doing.
 
  • Like
Reactions: oldrifleman
I have both and prefer single stage. I’m so used to 7oz and have yet to unintentionally torch off a round at a match. The 2 stage wasn’t light enough for me.
 
I Appreciate all the feedback! I can see the pros and cons to both and as everyone says, “it comes down to personal preference.” This RF build isn’t a week old and I haven’t even been able to accumulate the desired ammo I’d like to try due to shortages. I’m going to play with ammo once I have it until I find what works best, get comfortable with the rig, and worry about improving my fundamentals. All while keeping my eye out for a used tt-diamond.
 
I Appreciate all the feedback! I can see the pros and cons to both and as everyone says, “it comes down to personal preference.” This RF build isn’t a week old and I haven’t even been able to accumulate the desired ammo I’d like to try due to shortages. I’m going to play with ammo once I have it until I find what works best, get comfortable with the rig, and worry about improving my fundamentals. All while keeping my eye out for a used tt-diamond.
Personally I would grab the best ammo I could afford from what available and go shooting. Will you dial it perfectly, not a chance, but you will start to learn the rifle and how to shoot it. Time at the range beats time in the safe anyday. Face it the first few box’s are spent learning the trigger, lubing the barrel and learning the stock and scope relationship.
 
Last edited:
  • Like
Reactions: Sblzrd65
I use a 2-stage trigger in any rifle that I need to "slow down" before I break the shot. The trigger discipline needed to take the first stage up, without breaking the shot, translated to more control a heartbeat later when the shot came.
Not as much fun as a full auto mag dump, but better results down range :>)