odd question but i am curious if i can take a t3x tac a1 chassis and put a 7mm rem mag t3x action and barrel into it without any issues?
-
Having trouble using the site?
Post any issues in the thread below or reach out directly to support!
Contact support
tikka magnum in tac a1 chassis?
- Thread starter andrewstclair
- Start date
The action itself will fit fine, but the A1 chassis will only take short action CTR mags. I guess you could probably get a single shot follower or something that would work if you didn’t care about round capacity, but otherwise the mag inlet/length would be your main constraint.
Well that solves that thank you. Any suggestions for a similar chassis that will accept a tikka 7mm rem action and appropriate magazines?
Have put together a few magnums using the T3 TacA1
Opened bolt face to .535 (Which is simple and the tikka bolt design has the extractor in the same position for standard nd magnum bolt face)
Builds have included 7SAUM and 7wsm which both fed from CTR mag
Opened bolt face to .535 (Which is simple and the tikka bolt design has the extractor in the same position for standard nd magnum bolt face)
Builds have included 7SAUM and 7wsm which both fed from CTR mag
Not without a lot of tuning/bending the feed lips. Given the price of CTR mags, not sure you want to mess them up and risk it not working at all.
Similar threads
