Rifle Scopes leveling a H34L Aimpoint, no bottom flat red dot

A

AnglerDown

Supporter
Supporter
Full Member
Minuteman
Supporter
    • Mar 8, 2024
    138
    10
    New York,NY
    #1
    I have an Aimpoint H34L red dot which has a 34 mm round bottom tube. there are no flats on the bottom too use a wedge leveler. there are also no flat surfaces on the top. if I remove the battery compartment lid on the side there is a flat surface.

    How can I level this scope? I am trying to use a Spuhr one piece mount .
     
    #2
    I looked at the directions and the scope and I have come to the conclusion that it does not need to be leveled. The closest I could find is to use a sideways level across the top push buttons.
     
    #6
    I spent days leveling this n that had it all perfect ,put it on the kitchen table looking out in the back yard bagged in and the cross hairs were off......loosened the mount screws and turned the scope retightened the screws . tested at the range ....done
     
    You must log in or register to reply here.

    Similar threads

    mobo215
    Bubble Levels Suck
    Replies
    48
    Views
    2K
    Taylorbok
    Taylorbok
    M
    Repair older Aimpoint 5000XD red dot?
    Replies
    3
    Views
    232
    Marplot
    M
    M
    AICS stock help- install sawtooth arca rail with badger IMUNS
    Replies
    4
    Views
    154
    VSP968
    V
    gr8fuldoug
    Rifle Scopes Athlon Red Dot
    Replies
    0
    Views
    103
    gr8fuldoug
    gr8fuldoug
    Bilb0
    Remember to grab a Spuhr RDF red dot mount before their gone.
    Replies
    37
    Views
    1K
    91Eunozs
    91Eunozs
    Top Bottom
    Back
    Home
    Forums
    Merch
    Alerts