Alright, got my die cleaned up so it isn’t scratching the brass anymore…please tell me what I’m doing wrong now.
I left my dies setup the same way they were when I sized my virgin Lapua brass. Using a RCBS Matchmaster FL Bushing Die and a .287 bushing.
After running a few through I noticed the neck wasn’t sized all the way down. I started adjusting the die down so it sized more of the neck and the result are the attached pictures. Left to right is as I adjusted the die down more.
The right most case is about as far as it will go down while still allowing the bushing to move.
What the heck am I supposed to do at this point?
I left my dies setup the same way they were when I sized my virgin Lapua brass. Using a RCBS Matchmaster FL Bushing Die and a .287 bushing.
After running a few through I noticed the neck wasn’t sized all the way down. I started adjusting the die down so it sized more of the neck and the result are the attached pictures. Left to right is as I adjusted the die down more.
The right most case is about as far as it will go down while still allowing the bushing to move.
What the heck am I supposed to do at this point?