Put a 6.5 creedmoor together with krieger barrel , will shoot 10 shot groups under half moa. When the gas is turned on to cycle bolt(adjustable gas block) groups open to 1 to 1.5 ? Any advice?!?
-
Having trouble using the site?
Contact support -
Not receiving emails?
We're currently aware of an issue with our email provider and working to fix it as quickly as we can! Appreciate your patience here!
View thread
Aero m5 6.5 creedmoor build
- Thread starter Mk2jetta
- Start date
Sounds like you need to learn how to master the gas gun and shoot it with the gas open. They recoil and shoot much differently than a bolt gun.
Did a test back to back same results. Reloads (140s) and off the shelf fgm 140s both ammo same results.
Distinguished xtc shooter…thanks though, gas was off for break in
Last edited:
I built an aero m5 in 6.5cm and I had a hard time getting the buffer correct. Went through 5 or 6 different ones until I got a enclosed piston style. I adjusted the gas until I got elections to go to 4 o'clock and it has been great ever since. With the wrong buffer it was all over the place.
I'm working on load development for it now but sub MOA at 100 yards is fairly common.
I'm working on load development for it now but sub MOA at 100 yards is fairly common.
No offense intended at all, but is this your first LFAR ?
Large Frame AR's require a "different" shooting style compared to a AR15. It is hard to describe, but follow through is very critical to shooting precision groups.
Also, the added mass of the recoil cycle, amplifies any thing you can do wrong, when compared to a AR15.
Large Frame AR's require a "different" shooting style compared to a AR15. It is hard to describe, but follow through is very critical to shooting precision groups.
Also, the added mass of the recoil cycle, amplifies any thing you can do wrong, when compared to a AR15.
No have a couple rock river lar8s (zero issue) I’m going to pull apart and re toque barrel nut .
No odd damage to the rounds being cycled via the gas system being used ?
Everything good n' tight enough for the gas operation ?
Upper to lower fit maybe ?
And at the risk of sounding like a dip_shit... turning off the gas made your LFAR a "bolt" gun, with very little moving parts... so the cycling is the fly in the ointment.
What recoil setup ? And whose Adj. GB ?
Everything good n' tight enough for the gas operation ?
Upper to lower fit maybe ?
And at the risk of sounding like a dip_shit... turning off the gas made your LFAR a "bolt" gun, with very little moving parts... so the cycling is the fly in the ointment.
What recoil setup ? And whose Adj. GB ?
Last edited:
ODD indeed ,I've never experienced any difference in accuracy with any of MY gas guns . Whether single shot manual cycle or full clip throttle open ;Accuracy STAYS the same . At 165 yd. MY VV 560 load took a dump as I bumped up powder and it obviously didn't like it .
I won $110.00 at the range ,for sticking #11 ( all I had left ) old VV 560 loads with 143 grain Hornady pills and 6.5 StaBall . Some guy bet Me I couldn't put them under a dime at 200 yd. . He asked ME to change point of impact ,as after #8 he was suspicious they weren't actually going into the same place . So Last #3 , I put on the dot HE called for . His Buddy was using the spotting scope . He was lucky I only had #11 shots left at $10.00 per . Aero Precision custom build 22.5"
I won $110.00 at the range ,for sticking #11 ( all I had left ) old VV 560 loads with 143 grain Hornady pills and 6.5 StaBall . Some guy bet Me I couldn't put them under a dime at 200 yd. . He asked ME to change point of impact ,as after #8 he was suspicious they weren't actually going into the same place . So Last #3 , I put on the dot HE called for . His Buddy was using the spotting scope . He was lucky I only had #11 shots left at $10.00 per . Aero Precision custom build 22.5"
