Franklin F17 Removal of Front Sight

Are you going to keep the original forend?

When you see a front sight like that it’s telling you that accuracy was not the goal. It’s a plinker and irons should be fine.

Barn Side said:

...how best to go about removing the front sight?

Click to expand...

Like this:

phxfa said:

Are you going to keep the original forend?

Click to expand...

Relevant 'cause the front sight is what's holding that handguard retainer thing in place. You'll have to grind off A-frame part of the front sight and re-install it to hold everything together, or get a low-profile gas block to put on there (or re-do everything and get a free-float handguard, and keep in mind that there'll be two grooves cut in the bottom of the barrel that the pins went through).
Should end up with this(ish) if you grind the A-frame off:

You can grind the front sight down while it's attached to the barrel (which I think is how the one in the pic was done). How that turns out depends on your level of hamfistedness. I'm sure there's a youtube instructional out there.

Barn Side said:

Thanks for the replies.
I’m trying to decide between a LaRue qd scope riser or cutting the top off the irons with the dremel.

Click to expand...

This will get you to 1.93" w/o costing too much:
Will suck to get a cheek weld doing prone or other postitional. Off-hand should be good.
Still may see a blurry front sight at the bottom of your sight picture at low magnification.