I am looking to build a 6GT or 6 Dasher on a Gen 2 Ultimatum Deadline 3 lug action. I am a huge fan of AW mags from using them on the CDG. What is everyone's experience using these on a 3 lug action? For context, I'll be using a JP APAC for my chassis and was told that both the chassis and action will accommodate AW style mags.
-
Having trouble using the site?
Contact support
gray ops mags on 3 lug action
- Thread starter PRSDietitian
- Start date
They are the only aw mag I’ve ever used that have been flawless. I was to the point of just dropping the aw because of the headache until they came out.
Gotcha! I think for what it is, it’s a good deal. So I think I’m gonna go this route with this action and chassis combo.
Yes it is. I'm running AW's with it, though they've been a pain in my ass to tune. They seem to run alright now, but they were rough to set up.
My experience with AW mags is usually tuning the mag catch length until the mag is fully seated against the bottom of the action. If its cut for AW correctly that's about all you need to do. The Grey ops mag, as you know, can adjust the catch itself (same difference).
OP If you try and "tune" the gray ops mag feed lips you might have a bad day. Being milled aluminum and all..
OP If you try and "tune" the gray ops mag feed lips you might have a bad day. Being milled aluminum and all..
Last edited:
Started with the adjustable mag latch only, but the right side round would always get jammed up. Ended up having to tune the feed lips as well.
Gotcha! according to the owner of IBI who makes the ultimatum deadline actions, he says it's cut for AW, JP said they'll tailor the mag catch for the action. So I thought i'd give the Gray Ops mags a go and if it's a no go, then i'll swap to MDT AICS mags
Similar threads
