Second ever bedding job on a kelbly action. When I pressed the action into the marine Tex a little bit oozed up around the bolt release. I have good release agent in there, but I’m trying to decide if I should try and wipe it out before it dries or if that will just just push it further in and cause problems. I haven’t touched it or moved it yet. Thoughts?
-
Having trouble using the site?
Contact support
Bedding oozed into bolt release, how to get it out before it cures?
- Thread starter Bmil94
- Start date
Qtips and toothpicks to wipe it away. The smallest bit inside is less trouble than all of that outside will be.
Your'e not gonna get the stuff out from the bottom of it so I'd leave it to dry and as long as you released everything, it should come right off. You get in there with q tips and you may push it further into the crack where the release didn't go.
I pulled my bolt release on my actions and filled the void with modeling clay prior to bedding. Same with trigger opening and other areas. Keeps that devcon out of the action.
Similar threads
