Search results

  1. BIRDHUNTER

    6X5 Thread V5.0 *new 1/1/21*

    Here is my 2022 6x5. Best group.149 CTC best group MOA .285 avg. CTC .3256 MOA AVG. .6218 RimX, Green mountain barrel 1:16 Harrell tuner SK LongRange
  2. BIRDHUNTER

    NEW From Zermatt Arms - RimX Actions

    Yes it will shoot it. That being said I suppose the chamber you choose to run will have something to do with function and accuracy..mine is a Lilja 2 chamber. Greenmountain barrel 24”, just crowned. Here are some groups with inexpensive ammo at 50 yards..
  3. BIRDHUNTER

    Where to get ammo now post

    Here ya go.
  4. BIRDHUNTER

    Where to get ammo now post

    Mine shoots it pretty good.
  5. BIRDHUNTER

    6X5 Thread V5.0 *new 1/1/21*

    Thought I would post this since match ammo is tough to get And I found it interesting. Pretty good for inexpensive ammo. Prone, Ckye pod, W/Rear bag, 50 yards RimX Green mountain barrel, 24” crowned Manners T2A Vortex AMG Agulia Super Extra HV 40gr
  6. BIRDHUNTER

    6X5 Thread V5.0 *new 1/1/21*

    Prone, Ckye pod, W/Rear bag, 50 yards RimX Green mountain barrel, 24” crowned Manners T2A Vortex AMG Lapua center-X
  7. BIRDHUNTER

    Terrapin X vs Leica 2800.com with Kestrel AB

    Terrapin dose not have an internal target card function, however if you are using the kestrel you can create a target while using a connected kestrel. It must be done manually in the kestrel. Laser target A then B etc. then scroll down to the target card in the kestrel and it will all be listed...
  8. BIRDHUNTER

    First time shooting my own loaded ammo/Report... more advice needed

    That will work. Should get some good data.
  9. BIRDHUNTER

    First time shooting my own loaded ammo/Report... more advice needed

    You already got the .001 data, load up some with the .289 bushing and compare. If that was the first time shooting that brass the second round might print a little differently now that the brass is fireformed to your chamber. Don’t forget to measure a couple of pieces of brass after resizing for...
  10. BIRDHUNTER

    First time shooting my own loaded ammo/Report... more advice needed

    Where I would look is between 41.5 and 42.4. Load them up in .1 increments. Ex. 41,5, 41.6, 41.7 and so on. Scott Satterlee has a good video on how to use this method. Might have been a 6.5 Guys interview? In short, look at your speeds, you should find a flat spot among 3 speeds or so. Choose...
  11. BIRDHUNTER

    Should Bullet Base to O-Give measurements be the same?

    Sinclair is cut with a 1’30” taper just like most chambers. Hornady does not. That’s why there is a difference in measurement. Sinclair will give you a better comparison if you are working off a reamer print. Is it perfect no, is it a more accurate measurement of the olive, yep.
  12. BIRDHUNTER

    6.5 Creedmoor

    You have a hotter lot of powder. From a base line, lot to lot burn rate can be plus or minus 5%. What is your speed with 41.5grs?
  13. BIRDHUNTER

    284 Shehane

    No, pressure is good.
  14. BIRDHUNTER

    284 Shehane

    Not much info out there so I thought I would start one 284 Shehane 26” krieger 1:8 Bighorn TL-3 Long Action 6.5/284 Lapua necked up and donut reamed out 56.8gr 4831sc CCI LG primer Reamer specs - 235 FB, 317 neck 184 Berger Hybrid OAL 3.262 Loaded round, 312.5 neck, 310 neck bushing 2825fps
  15. BIRDHUNTER

    Safran/ Vectronix Terrapin-X *** Update***

    Very easy in A,B,C....modes. A mode laze, switch B mode laze, etc. each time distance and heading are loaded in. Then you just scroll between modes, A, B, C, etc. everything is in your kestrel. Elev and Wind for each target.
  16. BIRDHUNTER

    Range Report 6.5 Creedmoor Question

    Try this, set up a target at 25 yards with a small dot (or the shortest distance your scope will focus down to parlax free), pull up your dope for the distance, fire a shot, measure the distance off and adj your scope height number in your device until it matches the short distance shot. Once...
  17. BIRDHUNTER

    Giraud Case Trimmer question

    You will be fine. Neck bushing sizes down further down the neck than a full length die. Either way you should not have a problem. I run both and have never had a problem.
  18. BIRDHUNTER

    Kestrel 4500 Custom Curve ?

    Yes the 75gr ELD match is in there.