Search results

Search the forum Search Articles
  1. K

    RL15 for .308

    what is also interesting is that Xtreme has a post with a time stamp that precedes the answer you refer to... meaning that answer may not have been visible when he made his now redundant post...
  2. K

    Neck sizing causing runout.

    I am having similar result with 308 and I am using lee collet neck die... Has mostly started since brass has hardened and needs annealing but 001 to 002 shoot great the 004 to 006 shoot a lot worse, but I think its due also to neck tension being all over the shop... I have not turned necks so...
  3. K

    175gr SMK Varget load for GAP 308win Crusader

    OP was 2010...
  4. K

    Hornady Sonic Cleaner WTF ?

    My Hornady US with heater works fine.. not shiny but totally clean.. I could give a F@#K for shiny brass.
  5. K

    Range Report Chasing the Hole

    I recently did a ladder test.. 308 175SMK half grain increments from 39 grains to 45 grains Varget... so 2rnds at each load meant around 26 shots. Done at 330yds/300m the whole test was less than 1moa. That's 6 grains of powder from low to high, 26 shots around 3 inches spread. That tells me I...
  6. K

    Struck GOLD!!!

    I see there are a heap of primers on the shelf... ;0)
  7. K

    Moving away from hand primers

    well I have always wondered about the risk so from your post it seems real... I have never hand primed a single case in the 30 years since I started reloading. But I guess one should always wear the eye protection... sometimes I get lazy... EDIT: I have used the RCBS Auto mostly
  8. K

    Bolt won't close on reloads .308

    long time lurker.. first post.. had to start some time.. Darkside, I don't have the answer but I have had the same issue Rem brass. When I pulled the bullet the empty shell would chamber and often if I rotated the loaded round 90 degrees in the breach they would be ok. I marked some of them...
Top Bottom
Back
Home
Forums
Merch
Alerts