Search results

Search the forum Search Articles
  1. U2AV8R

    Range Report .308 loads using 4064?

    Re: .308 loads using 4064? Check your twist for 155s out of an M14. Tried them years ago in a 10 twist and they are OK out to 300 but go to hell at 600. 168s and 175s were good all over. The good ole standard of 41.5 of IMR 4895 in a LC case never let me down in a match.
  2. U2AV8R

    Range Report Moly B and accuracy?

    Re: Moly B and accuracy? I don't think it's been proven that moly increases or detracts from accuracy, but cleanup is a snap. No copper fouling to worry about.
  3. U2AV8R

    Post Transonic-Sub MOA Accuracy

    Re: Post Transonic-Sub MOA Accuracy Bullets after the going through the transonic become upset and tumble. These loads are easily identified by the full profile impacts on paper targets at 1000 yards. Also back on the spotting scope at the 1000 yard line, if the climatic conditions are...
  4. U2AV8R

    Federal Gold 711B and 719 questions

    Re: Federal Gold 711B and 719 questions +1 on Champion's Choice. Also, Tony will tell you what lots are performing. Get a couple of boxes of some recommendations, test them and then buy the winners in mass quantities. Wolf, SK, 711B, and Eley red and black box run in my 1907. Worst by far...
  5. U2AV8R

    Rifle advice .308 for long range

    Re: Rifle advice .308 for long range Watch the Savage triggers. At the 2007 World Championships at Connaught Range in Ottawa, Ontario, one of the Young Eagles' rifle went down when a plastic part of his trigger gave up. FWIW.
  6. U2AV8R

    Fieldcraft killflash/pantyhose question

    Re: killflash/pantyhose question Should we call this setup a "Brazilian"?
  7. U2AV8R

    Hunting & Fishing Which Bullet?

    Re: Which Bullet? You won't go wrong with either choice. It's all about shot placement. Your job is to take all the other factors into consideration, wind, target speed, light...
  8. U2AV8R

    Maggie’s my mistress

    Re: my mistress "To wives and sweethearts ... May they never meet" - Captain Jack
  9. U2AV8R

    Maggie’s **** Daisy Dukes.... RULE !!!!!

    Re: **** Daisy Dukes.... RULE !!!!! Built for comfort and not speed. Ruined the Cowboys with Romo's distractions. Next...
  10. U2AV8R

    Suppressors Got the call today... YAY!

    Re: Got the call today... YAY! Wives aren't that stupid. They check caller ID!!!
  11. U2AV8R

    Suppressors srt titanium xl

    Re: help me decide Doug is good people. His products do very well too. You won't be disappointed with anything from SRT.
  12. U2AV8R

    Suppressors how long is it taking now

    Re: how long is it taking now My last transfers to a trust took 11 and 12 weeks. That was last week.
  13. U2AV8R

    Suppressors Got the call today... YAY!

    Re: Got the call today... YAY! Hope it's quicker than that!
  14. U2AV8R

    155 or 168 ?

    Re: 155 or 168 ? Definitely dependent upon barrel twist rate. 155s need a 13 twist for optimum performance. Shot 155s out of an M1-A for a couple of matches in a 10 twist barrel. Shot OK at 200 and 300 but wouldn't hold the 9 ring at 600. Switched midstring to 168s and finished up well...
  15. U2AV8R

    Wanted 308 win brass any brand

    Re: Wanted 308 win brass any brand I have Lapua and Winchester in large quantities. Email me with your requirements.
  16. U2AV8R

    help settle this powder issue please

    Re: help settle this powder issue please Don't think you're going to be disappointed with either H4895 or Varget. The Hodgdon Extreme powders are the most thermally stable powders I've come across. Pressures stay the same, hot or cold, high pressure altitude or sea level.
  17. U2AV8R

    Dumb question about shooting sling use

    Re: Dumb question about shooting sling use +1 on marking the sling positions. If you're using leather MRT type slings, just remember after years of use, the leather stretches.
  18. U2AV8R

    Gunsmithing Gunsmiths near Temple or Arlington TX or OK City

    Re: Gunsmiths near Temple or Arlington TX or OK Ci Doh! 940.566.7001 and Stick will probably answer the phone. His shop is in Argyle, south of Denton.
  19. U2AV8R

    Gunsmithing Gunsmiths near Temple or Arlington TX or OK City

    Re: Gunsmiths near Temple or Arlington TX or OK Ci You might also consider Don "Stick" Starks at S&S Precision. He did most of Speedy's metal work while at SG&Y. He's the only guy that touches my guns now.
  20. U2AV8R

    Rifle Scopes ACOG OR EOTECH for CQB?

    Re: ACOG OR EOTECH for CQB? As has been said, in a CQB environment, field of view. EOTech hands down.
Top Bottom
Back
Home
Forums
Merch
Alerts