Search results

Search the forum Search Articles
  1. O

    .224 Valkyrie

    So just for kicks I just used 20rds of 60gr federal with no issues.....I dont plan on using factory ammo but this one has me perplexed.
  2. O

    .224 Valkyrie

    Ok so on the .224 road to the best round. So far the 90gr Berger and RL17 is my go to. Haven't gone to 80.5gr yet but planning on load development this spring. Anyone use this round yet? On a side note. I tested some 88gr Hornady factory load at 500-600yds. The rounds were consistent enough but...
  3. O

    90 gr berger .224 load with varget?

    Lol. I posted in the wrong one
  4. O

    90 gr berger .224 load with varget?

    Ok so on the .224 road to the best round I tested some 88gr factory load at 500-600yds. (Non-adj gas block and I'm 100% it's in the right position.) The bolt wont cycle firing them. No sticking but doesnt come back far enough to grab the next round out of the mag. WTF over?
  5. O

    .224 Valkyrie

    90gr Berger VLD 27gr RE17 Federal Brass COAL 2.26 CCI 400 2700-2708FPS 24" Faxon 1/7 barrel, SJC Titan compensator, rifle length gas system. Taken it out to 1,000yds
  6. O

    .224 Valkyrie

    24" 1/7 Faxon Barrel 2.260 COAL 90gr Berger 27gr RE17 CCI primer 2750 ( 5-7fps deviation)
  7. O

    Bergara b14 HMR

    That's good to hear. I have played with both and leaned to the HMR. I am stepping into 6.5cm so it is unfamiliar territory for me but I know the barrels wear out faster then 5.56 and 7.62 so I like to know what I'm sticking my nose into.
  8. O

    Bergara b14 HMR

    Has anyone re-barreled an HMR yet? I'm intereted to know if a barrel but fits in the original stock. I've been reading about both the HMR and the RPR and trying to decide between the two.
Top Bottom
Back
Home
Forums
Merch
Alerts