• RIX Storm S3 Thermal Imaging Scope WINNER!

    Thank you to everyone who particpated!

    See the winner

175 smk

  1. txbass97

    SOLD Factory Match Ammo - SOLD

    I’ve gotten to the point I only shoot reloads, time to offload the rest of my factory ammo. Buyer to pay actual shipping, as I’m pricing these at the lowest price found on Ammoseek per round. Located in DFW TX for local deal. Zelle (preferred) - Venmo - PayPal FF accepted - not looking for...
  2. LongRange98

    SOLD .308 match ammo

    Up for sale some .308 match Ammo 185 Federal Berger juggernauts 167 rounds for 240$ 175 gr Federal SMK 175gr 100 rounds for 130$ 168 gr SMK Federal 200 rounds for 240$ Shipping will be 20$ NOT for sale in CA all other states ok, Know your state laws before ordering.
  3. H

    StaBALL Match Review

    I went to the range on Saturday to do some testing with StaBALL Match with my 24” Savage .308 Win. This range trip I was only looking at velocity by powder charge weight. I decided not to measure group size on this trip given I use a MagnetoSpeed chronograph which hangs on my barrel. My...
  4. F

    .308 win 175smk 20" 2650fps Powder Charge?

    Howdy all, Im looking to push a 175gr SMK to 2650fps out of a 20" Remington 700 short action so my ACSS Apollo BDC is accurate past 800yds. Bit of an ask out of an 20" I know but i believe its doable. My question is has anyone produced loads that replicate the performance I'm looking for...
  5. E

    Accessories FS: 308 Projectiles - Price drop!

    For sale is a Remage 26”, 1:10 twist, MTU contour, Criterion (CBI), 5/8x24 muzzle threaded, 308 Winchester barrel. There are 550 rounds logged, all ammo has either been factory or reloads. No barrel nut is provided. Remage barrel - $275 Additionally, these 2 lots of projectiles. Keeping them...
  6. grassy knoll

    SOLD SOLD 260 rounds of M118LR

    260 rounds of M118LR in the box. The picture is missing a box, mistake on my part, but you will receive the correct amount. $400 shipped. No trades.
  7. D

    First ladder test. Looking for suggestions.

    Hi all, I shot this ladder test at 300 yds from the prone off of a bipod and rear bag. I'm looking for suggestions on best starting place for further load development. I think the most consistency is around 42.4 and 44.0 grains, but I think that 42.4 may not be getting the most out of the .308...
  8. 1

    Blowing primers at MINIMUM load?

    Need a little help here. I have been reloading for over 10 years and have never had this happen before, so now i am stumped. Rifle: DPMS LR 308 24" barrel Brass: LC 11 Match prep (FL resize with Redding competition die, swage primer pocket, trim to 2.010", debur flash hole, chamfer case mouth...