drill

  1. Near miss

    Different qualifications

    Hello, I thought of asking over here what kind of firearms qualifications you have ran into? I noticed doing qualification training drills makes good progress. I would really like to learn new qualification drills to add some variance into my training. Please post any qualifications or drills...
  2. 03psd

    Gunsmithing Simple Drill & Tap + Barrel Thread: Who?

    With all the great custom builders out there doing full custom builds, is there anyone decent who still does relatively simple gunsmithing but with high quality? I dont mind a reasonable wait but dont think it should take as long as a full custom job either. Someone must have this niche covered...
    • 03psd
    • Thread
    • barrel drill simple tap thread
    • Replies: 2
    • Forum: The Armory
  3. 7mmRM

    Photos .5" dot drill

    223AI. 100yrds. Prone/Bipod. Pretty fun little target. I dicked up 2 and 8 pretty good.
  4. TBass

    Photos Dot Drill shot at 109 yards

    This dot drill is a very humbling experience. I actually shot the target at it appears (I shot it sideways, instead if placing the target up & down). I did not take any zeroing shots, as I had shot the day before & the conditions were almost identical. After every shot I stood up and got back...
  5. D

    Photos My 1st dot drill

    I had a blast shooting this, the grouping i shot after i did the dot drill and the barrel was hot and i was worn out. The gun still out shoots me.
  6. N

    Deburring tool for drill press?

    ...please tell me there <span style="font-weight: bold">IS</span> one! My fingers aren't gonna last doing it with the Lee tool... Any recommendations?
  7. Keith Johns

    Gunsmithing Custom Drill and Tap size (.578 x 28tpi)

    I've been checking around to see if I can find a bottom tap anywhere in .578" x 28tpi. When I finally got a price quote it was $160 for a HSS tap, 2" OAL. Wont spend that much. Does anyone know where to find a tap that size or am I going to have to cut female threads with the lathe? Thanks in...
  8. K

    Anybody use a Drill Press to trim cases?

    I'm on the list to get a Giraud but it is looking like up to 6 weeks for shipment. I was wondering if you could get good results using a quality drill press...does anybody use a press with the Forster Power Case Trimmer? Do you get good results? Thanks!
  9. F

    Handy new use for my Drill Press

    I'm running through about 500 once fired .308 brass I just purchased and I've started using my small bench top drill press in my reloading work flow. I started by mounting a .410 shotgun bore brush in the drill's chuck to clean out the inside of the neck after tumbling. I leave the press running...
  10. GaryinCC

    Rifle Scopes lets see your box drill on your scope

    i am reading alot about Falcon and millet scopes and i have searched to see if some one has posted a report on a box drill with one of these scopes. in my opinion the first thing that a tactical scope has to do is track. everything else is second. so i'm asking for the owers of new to the...
Top Bottom
Back
Home
Forums
Merch
Alerts