ejector

  1. P

    Help/advice desperately needed

    Hello Everybody. I hope somebody can help me here. I am a newbie. I recently bought my first AR-10 6.5 Creedmoor. I built the lower and I got a complete upper (I got all the parts from Palmetto Armory). The rifle had some extraction/ejection problems and was putting a lot of scratches on the...
  2. J

    Newb Question! Ejector marks on .300 win mag brass

    I own a Remington 700 chambered in .300WM (item #85505). It has a 26'' stainless steel 5r barrel. I am relatively new to hand loading, but I'm very meticulous and take my time to follow all the necessary safety precautions, and measure cases/charges. I recently started trying to work up a load...
  3. JaysonF

    A few things I learned while working on my Savage bolt

    I have been doing a lot of dry fire on my rifle and I noticed that the extractor wasn't working well on the "A-zoom" .308 Win snap caps. I haven't had a chance to take it to the range yet so testing it with live ammo hasn't been an option. I did some research and found that a lot of people...
  4. scudzuki

    Remington 700 ejector stuck

    After about 10 rounds downrange today the ejector pin in my fairly new (less than 100 rounds down the pipe) Remington 700 bolt got stuck inside the bolt, flush with the bolt face. I tried to coax it out at the range unsuccessfully, then shot 10 more rounds, digging each round out of the ejector...
  5. H

    Gunsmithing 22-250 blowing out ejector pins?

    I have a friend that has a new left hand savage that has blown out two ejection pins. The first time he told me about it I automatically thought that he was loading it up to hot. But after loading up some ladder rounds his brass started showing overpressure sings at less than mid load. Loads...
  6. A

    ejector mark Gurus I have a question

    does the mark/Flow happen before the bullet leaves the brass or is it a couple inches down the barrel or toward the end or a combination of issues ?
  7. G

    Sig/Blaser LRS1 ejector issue

    I (well, my department) have a LRS1 Blaser and when I shot it this weekend I had an issue with rounds hanging up short of the chamber. I eventually figured out the rounds were popping up to feed but were jumping up over top of the ejector. The ejector is a spring plunger with a small rounded...
Top Bottom
Back
Home
Forums
Merch
Alerts