tension

  1. S

    SOLD atlas psr bt46-lw17 with victor company tension wrench 270 shipped

    atlas psr bt46-lw17 with victor company tension wrench 270 shipped Used 1.5 years, perfect working condition
    • Slate264
    • Thread
    • atlas atlas bipod atlas psr bipods cheap tension tension wrench victor
    • Replies: 2
    • Forum: Buy - Sell - Trade
  2. 4Rail_Gunner

    260 Rem Neck Tension

    How much neck tension are you guys running on a 260 Rem. Using Rem Brass, outside loaded Diameter shows around .291" Would a .288 Bushing be to much neck tension? Will be loading from a AICS Mag. Thanks
  3. H

    Unexplainable high neck tension after annealing

    I'm a at loss of words to what I experienced yesterday while reloading. I was reloading some 175 SMKs in Lapua .308 brass yesterday when I experienced some unusually high neck tension. This was with Lapua brass that had been shot 6x and I had just annealed the brass using the Hornady annealing...
    • Hunt
    • Thread
    • annealing high neck tension unexplainable
    • Replies: 14
    • Forum: Reloading Depot
  4. D

    OAL and case tension

    Hey All, Total Noob here. I have a factory rifle and to get decent accuracy I must load long. I'm currently at 2.900 OAL and 2.940 puts me into the lands with 175 SMK's. I would like to stretch out to 2.925 but when I measured how much bearing surface was in the case neck, it mic'd out at...
  5. S

    408 CT: neck tension / crimping.

    What neck tension are you using on bullets W/O a crimp band I.E. RMB jacketed. Do you crimp bullets with a band? The TTI ammo I'm using has a slight crimp, I have just about exhausted it and ready to reload, have bullets with and W/O band, rifle EDM WR.
  6. U

    Any experience with CEDLoad force neck tension

    Has anyone used a CED Load Force 250 or similar load cell systems to determine bullet seating force and neck condition. Did sorting ammunition with identical seating values enhance performance and ES or POI, if so to what extent? I anneal rounds after each five firings but would like to control...
  7. J

    Neck Tension

    I just got a new 308 barrel that is marked .342 neck. The good folks of the hide educated me to what the .342 neck means, but it opens a hole new area for me to explore. It is my understanding that the .342 is not a tight neck, but if I had chosen a tighter chamber neck and had to turn the...
  8. Wheres-Waldo

    Does annealing reduce neck tension?

    I just finished annealing my entire lot of cases after their 3rd firing. I tumbled, then annealed, then did my brass prep as if the cases were straight off the range. Neck tention was still set at .002" but felt like next to no tension at all when seating the bullets. Things will work-harden...
Top Bottom
Back
Home
Forums
Merch
Alerts