Fellow shooters, I have a Tikka Tac A1 I'm beginning to build, and am curious about scope mounts I'm considering right now. The two brands being considered are the Badger Ordnance Condition One unimount or the Spuhr mount for a 34mm scope tube. I believe the rifle's rail has 0 cant to it as is. The scope to be mounted on it will be a Primary Arms Platinum FFP 6-30x56 Apollo with the 6.5 CR ACSS reticle. I plan on using this rifle for long range target plinking, varmint hunting at night with a thermal clip-on, as well as deer hunting in South Texas.
I have a 20 MOA cant mount on my DT SRS A1 in 338 LM, and I've never run out of elevation adjustability with my NF scope on it.
Not looking for a QD mount, since I don't plan on changing out scope to anything else. May mount a mini red dot on the ring, for close range quick shots.
What I am curious of is, if I go with a 20 MOA cant on the scope mount:
1. What height/MOA cant combo of mount should I utilize for the 56mm objective with Butler Creek cap, that will align properly when I put a thermal clip-on in front of it?
2. Do I need to stick with a 0 MOA cant, utilizing a higher or lower scope mount at 38mm(1.5") or 44mm(1.73"), to work with the thermal?
Input appreciated, thanks.
I have a 20 MOA cant mount on my DT SRS A1 in 338 LM, and I've never run out of elevation adjustability with my NF scope on it.
Not looking for a QD mount, since I don't plan on changing out scope to anything else. May mount a mini red dot on the ring, for close range quick shots.
What I am curious of is, if I go with a 20 MOA cant on the scope mount:
1. What height/MOA cant combo of mount should I utilize for the 56mm objective with Butler Creek cap, that will align properly when I put a thermal clip-on in front of it?
2. Do I need to stick with a 0 MOA cant, utilizing a higher or lower scope mount at 38mm(1.5") or 44mm(1.73"), to work with the thermal?
Input appreciated, thanks.
Last edited:
