Reloading Equipment 1x fired alpha 6BRA brass price drop

[MC919]

For sale is 1170 pieces of once fired 6bra ocd brass.
Will do lots down to 200 or sell all at once! $.85 per piece shipped.
I also have 117 3x fired that I’ll sell for .70$ per piece shipped.

Speeds on all were 2800, no pressure and it shot great in a stuteville precision barrel. It was chamfered/trimmed on a giraud.

 

[MC919]

Up

 

[MC919]

Up

 

[4O6shootist]

Are those 205m primers? They look pretty flat/cratered for 2800fps. Just curious as I'm looking for some bra brass.

 

[MC919]

They were br4’s and they aren’t cratered at all. The edges of the primers are still rounded…. No sweep marks at all…
I’ll post a better pic just for you.

Thanks for the steaming pile of crap bud.

 

[4O6shootist]

They were br4’s and they aren’t cratered at all. The edges of the primers are still rounded…. No sweep marks at all…
I’ll post a better pic just for you.

Thanks for the steaming pile of crap bud.

Not trying to be an ass. I just see primer flow here in these photos, that's all. Maybe the pin has a lil more clearance in the bolt face. Its just a question, assumed 205m as they notoriously soft.

Heres some virgin brass ran through my rifle at 2880fps from a 28" barrel. Yes i know there's ejector marks, but zero lift or anything else, it's growing 006 in headspace and assume the stamp is from bolt slap(same marks occur at 2700fps). None of my primers have flow, this is the reason I asked. The zoomed in photo may just make the primers look bad and they're not.

 

[MC919]

I think what you are seeing on some of the pieces is the remnant of the
‘B’ denoting it’s a br4.
Regardless, i just went and looked at a lot of them. They feel fine when you run a fingernail over them. I’ve never had hard bolt lift or sweep marks and it runs at 2800 exactly. 26” barrel.

 

[Sprayed99]

Not trying to be an ass. I just see primer flow here in these photos, that's all. Maybe the pin has a lil more clearance in the bolt face. Its just a question, assumed 205m as they notoriously soft.

Heres some virgin brass ran through my rifle at 2880fps from a 28" barrel. Yes i know there's ejector marks, but zero lift or anything else, it's growing 006 in headspace and assume the stamp is from bolt slap(same marks occur at 2700fps). None of my primers have flow, this is the reason I asked. The zoomed in photo may just make the primers look bad and they're not.View attachment 7866094View attachment 7866105

This is why you ask this type of thing in a PM, because some people have no idea what they are looking at. Those primers are just fine and its more than likely an impact action which will leave a raised edge on the dimple even if you squib a damn bullet without powder.

OP I'm sending you a PM to get some information.

 

[MC919]

Up

 

[MC919]

Updated