Is there any real advantage to using Edge dies over 338 RUM dies? Would the RUM work just as well? What about using 338 RUM neck dies.
-
Having trouble using the site?
Contact support
338 Edge dies
- Thread starter Goin'Hot
- Start date
Re: 338 Edge dies
If I'm not just talking out my ass.... The 300 RUM case is longer than the 338 RUM case, so I'd say that would be a disadvantage.
If I'm not just talking out my ass.... The 300 RUM case is longer than the 338 RUM case, so I'd say that would be a disadvantage.
Re: 338 Edge dies
The difference in length is 0.090". The taper at the base is the same so, that's the reason for the question.
The difference in length is 0.090". The taper at the base is the same so, that's the reason for the question.
Re: 338 Edge dies
I sent out a redding 300 RUM full length sizer out for to be bored out for 338 and type S bushing neck. I had the 300 RUM sizer laying around and doing me no good so the conversion seemed to make sense for me.
I sent out a redding 300 RUM full length sizer out for to be bored out for 338 and type S bushing neck. I had the 300 RUM sizer laying around and doing me no good so the conversion seemed to make sense for me.
Similar threads
Reloading Equipment
Die Sets - RCBS
