Since the 33xc has been out for a little while now, has many people had any expericence with it? I am interested in one. I have a 2000 yard target i can frequently shoot and I am looking hard at the 33xc. thank you
33xc
- Thread starter jaybigboy34
- Start date
Hi,
The most frequent posters that may be able to help you are spread out in this thread here...
www.snipershide.com
Towards the newest pages there is some good information!!
Sincerely,
Theis
The most frequent posters that may be able to help you are spread out in this thread here...
The new 33XC & 37XC cartridges designed by David Tubb
Hi, I was wondering what everyone's thoughts were on these new cartridges?
www.snipershide.com
Towards the newest pages there is some good information!!
Sincerely,
Theis
I had a Schneider 32in 1-8 twist barrel for my AXMC and had a lot of issues with pressure. Could have been my barrel. I was only able to load 104 gr of H-50 BMG with out getting flatten primers with bad creators. Other guys have had great luck with theirs
FYI- 33XC users are loading 120 - 124 grains of H-50BMG with 300 gr lead core bullets. Velocities and accuracy range of 3150+ fps typical. Paul Phillips shot his 33XC (34" barrel) with the Cutting Edge (275 gr) at over 3500 fps for a few shots. Best accuracy is probaby 150 fps slower.
My fired brass full length resized (neck/shoulder set .005" and base of the case diameter reduced .0015") shoots equally as good as new brass with lead core bullets.
My fired brass full length resized (neck/shoulder set .005" and base of the case diameter reduced .0015") shoots equally as good as new brass with lead core bullets.
I am having Mile High build me a 33xc barrel for my AX MC. It will be a Bartlein 5R - dont k ow twist yet. I want the .250 free bore for boh jacketed and solids. They are tenting the reamer from Mr Tubbs I believe (or someone anyway). I need to contact Mr. Tubbs for dies and Petersen for brass once barrel confirmed but I am ready!!
Hope you had better luck then I did. Had a 31 in Schneider barrel (these are what Tubbs uses)for my AI-PSR and could never solve the pressure issue. I know other guys have had great luck.
also have a 375cal Schneider P5 barrel that was showing early pressure..... different cartridge though.
