Title says it all please help a brotha out here. I can't find anything in stock or without a 4-6 week lead time. Thanks
WTB 6.5 creedmoor mandrel dies
- Thread starter dkramper
- Start date
Wanting To Buy
Try https://portersprecisionproducts.com/expander-mandrel-die/. Just got mine a few weeks ago and he had everything in stock.
thanks gonna reach out to him right now. I am up in michigan till tuesday so looks like it will work out
Caliber Specific Expander Mandrel Kits
Our caliber specific expander mandrels are available in .0005” increments in calibers 22 to 338 and will range from .001” above bullet diameter to at least .003” below bullet diameter depending on caliber. This will allow the reloader to find proper neck tension to fine-tune their loads. The...
21stcenturyinnovation.com
I would love to try and work with them. I even had a 3 hour conversation with "speedy"(hall of fame bench rest shooter) about them and what I was doing wrong with reloading in general. Great guy he even told me to mention that he sent me to them. However I have tried to reach out to them via phone 3-4 times now and can't seem to get a answer or call back. Not to over inform, but I was driving to Michigan this weekend and was hoping to swing by the 21st shop and thank the guys for the great work as they came HIGHLY recommended from speedy. But the website says 4-6 weeks lead time and I am out of ammo lol and have 3 matches between now and then. lolyou would have to look around for the full kit if that is what you want or a specific one also available .Caliber Specific Expander Mandrel Kits
Our caliber specific expander mandrels are available in .0005” increments in calibers 22 to 338 and will range from .001” above bullet diameter to at least .003” below bullet diameter depending on caliber. This will allow the reloader to find proper neck tension to fine-tune their loads. The...
Last edited:
This system is very good. The collet holds the pin gauges dead center. The gauges are available in .0005 gradation in the - or + tolerance. I am currently running .2625+ for 6.5 creedmoor annealed brass
