6mm Dasher best die's

[Maxim0]

Looking for opinions of best 6mm dasher dies. Well reasonably priced at least don't want to spend 600 on a custom. Just starting my rifle build so not sure on what bullets/brass I'll be using but from what I've been reading it seems lapua brass with berger bullet is the way to go. Also with a wildcat case like this do you need any additional tools like a neck turner? I've only reloaded 308 thus far, so don't have much experience. Any help would be greatly appreciated. Thanks!

 

[Dai Bando]

Buy a Harrels FL sizer and a Forster Bench Rest seater.

 

[One1Bravo]

Whidden Click to Adjust and micrometer seater are my go to dies. So easy to set up and mine have been spot on.

 

[spife7980]

This is what I did

Forster dasher die is 36 bucks right now https://www.opticsplanet.com/forster-full-length-sizing-die.html?_iv_caliber-193146313=6mm-dasher

Forster Micro seater is 87 https://www.opticsplanet.com/forste...13=6mm-dasher&_iv_code=2RJ-R6-FRUMCRSD-U00038

code work7 is 5% off

 

[Maxim0]

Buy a Harrels FL sizer and a Forster Bench Rest seater.

Any reason to use the harrels sizer over the forster?
https://www.forsterproducts.com/product/bench-rest-die-sets/

 

[spife7980]

Any reason to use the harrels sizer over the forster?
https://www.forsterproducts.com/product/bench-rest-die-sets/

They harrels has several different models that each vary slightly by a thousanth or two between models and they choose the version that is a best fit for your fired brass samples that you send in, its super cool. That said its twice as expensive.

 

[Maxim0]

They harrels has several different models that each vary slightly by a thousanth or two between models and they choose the version that is a best fit for your fired brass samples that you send in, its super cool. That said its twice as expensive.

I don't mind paying for quality. Will definitely check those out. Thank you
** edited the downside to harrels is they want 3 pieces of brass that have been fired three times in your chamber. How do I get 3 firings prior to buying a die. Or do they have just neck sizing dies like other calibers

 

[ingraham]

If you chose to go the Forster route be aware that unless you go with the neck size / shoulder bump die you will not have the choice of using bushings , you'll be relegated to having them hone out the neck portion of a F/L die in order to avoid over working the necks... I have a set of Forster BB neck dies and albiet they are very nice they are'nt a F/L die.

Talk to the boys at Harrells or as mentioned drop whidden a line they are very nice to deal with.

 

[FishDr]

Once I’ve determined the brass and bullet to be used, I prefer the Forster FL die and Benchrest seater. Honed of course to prevent overworking. Never felt that it was inferior in any way.
Edited to correct the autocorrect mis-spelling.

 

[Sniper260]

Send your fired brass to harrels for a custom dies. Or buy your own reamer and have dies made to your chamber, and a fireform barrel to not waste your good barrel making brass.