Good afternoon from WA State. Haven't posted in a while.
So. I got an opportunity and could not pass it up. An AI in .308 (A MkII, I believe), with a Leupold 3.5-10 on it for $`1500. I snapped it up.
Got it out to the range, and intended to just do three foulers at 100 yards. I should mention that this rifle is a trade-in from a local SRT team.
I have a very small stash of Hirtenberger .308, 147 grain ball, and that's what I used.
Holy cow! First target is the three rounds of Hirtenberger...then, five of 168 grain GMM and five of 175 grain GMM--and that was with a VERY dim optic that completely subtended the center of the target. I'm about to put an NX8 on it and reshoot.
Here are my questions:
First, how hard is it to change the barrel on one of these rifles? I have seen a couple of videos, and it looks pretty straightforward.
Next, where do I get the wrench from to do it? What is the twist rate on these rifles?
Finally...any information you all can pass along is well appreciated.
So. I got an opportunity and could not pass it up. An AI in .308 (A MkII, I believe), with a Leupold 3.5-10 on it for $`1500. I snapped it up.
Got it out to the range, and intended to just do three foulers at 100 yards. I should mention that this rifle is a trade-in from a local SRT team.
I have a very small stash of Hirtenberger .308, 147 grain ball, and that's what I used.
Holy cow! First target is the three rounds of Hirtenberger...then, five of 168 grain GMM and five of 175 grain GMM--and that was with a VERY dim optic that completely subtended the center of the target. I'm about to put an NX8 on it and reshoot.
Here are my questions:
First, how hard is it to change the barrel on one of these rifles? I have seen a couple of videos, and it looks pretty straightforward.
Next, where do I get the wrench from to do it? What is the twist rate on these rifles?
Finally...any information you all can pass along is well appreciated.