Accuracy International AT Night Vision Bridge

[Edsel]

After half a decade - I finally decided to install the night vision bridge I bought with the rifle then.

The screws are too tall!

They tend to make barrel reinstallation an annoying process.

Anybody else run into this issue?

 

[scotchtape]

What's the OAL of the screws?

 

[Edsel]

Can’t tell you the exact length at the moment - but they’re around half a centimeter or so taller than my other rifle’s night vision bridge (no protrusions on that one).

 

[samb300]

I'd call Mile High and find out the correct size, or just run to your local Ace Hardware and buy two screws that are a couple millimeters shorter,

 

[Edsel]

Called both Mile High and EuroOptic earlier today...

I’ve been directed to AINA.

Waiting for their reply.

 

[_Windrider_]

Operator as fuck with one of these. @lowlight

 

[Edsel]

That’s where the phone and camera attach to

 

[Edsel]

AINA’s sending a pair of screws...

 

[Edsel]

What's the OAL of the screws?

The correct length is 18mm, which I just got from AINA today.

The older ones were 21mm.

Not sure of the pitch, I don’t have one of those pitch gauges.

 

[Canuck1977]

I did had mine cut by a machinist.

easy, fast and cheap

 

[Edsel]

I've done that myself on the rear action screws of my less expensive rifles - but for my AIs, I want everything correct from the factory.