Ok, got the front rail for my PVS27, Gap in an AICS AX chassis, 20 moa mount. The bell of scope, S&B PMII 3-20x50, rings Badger highs @ 1.375”, hits the front rail, the flared area at very end of bell. Question one, what’s best way to try to align better and get bell off rail? Highest rings I can find are 1.5” so gain of about an eighth of an inch approximately. Change scope base? 20 moa Badger , to 0 moa cant, would it bring bell up an eighth of an inch as slant from rear to front is approx an 1/8th”lower than rear?
I understand alignment is not key on these, but would love to get close, and get that ring on the bell off rail
Suggestions,welcomed
I understand alignment is not key on these, but would love to get close, and get that ring on the bell off rail
Suggestions,welcomed