Anschutz 2013 BR manners

[Travis224]

I acquired this rifle earlier this spring knowing it was only a good price at the time but not really exactly what I have a use for and I had a Manners LRH non-minichassis that I was kicking around selling so once I looked at the logistics of milling the stock and bedding it for the Anschutz, I held my breath and started cutting. Took me about 45min on the mill to get it real close, and got the pillars ready. Now I have to drill for the pillars and epoxy them and begin the wait

As far as the barrel, I wanted to try something new and with a little planning, I had my gunsmith cone the breach on a Kidd stainless barrel and with 50 rounds thru it, I found it really really likes SK and once the weather gets better, I have some center X to try.

Fun tinkering project, I don't have any reason to no think this will be a great plinker even if it is only a single shot

 

[SMH]

You have me thinking...
I have an Anschutz 2013 in the Aluminum Free Rifle stock and a Manners MCST that I'm not using.
Might make a fun and (relatively) simple project!
Are you running pillars and no other bedding or glass bedding as well?
I was thinking of glassing in the mag well, skipping the pillars and just glass bedding the big flat 2013 action.
Any thoughts on that?

 

[Travis224]

I'm going to try my best to run pillars and I have a BDL floorplate that is M5 so I can hide the rear 2 screws. Other than that, I'm going to bed the whole rest of the action in. So far, it's been pretty easy!