-
Having trouble using the site?
Contact support
Anyone running the new AI AT-X chassis…
- Thread starter Tokay444
- Start date
Not an impact.........but an aw cut lone peak fuzion. My rigs a 6bra and feeds the first 7 rounds from an aw mag with hrd kit well, the last 3, not so much. But it's done this in every chassis/bottom metal I've tried. Bought the mag 2nd hand and obviously needs some tuning. I run arc mags with 98% no feeding issues. There's a small tab that's screwed in the top side of mag well rear inlet that keeps aics mags from putting upward pressure on the bolt. If you remove this it allows the aw mag to ride higher, could only be a good thing with these mags that offer low case head presentation.
Last edited:
Negative unfortunately. Only downfall of the chassis. I love everything else about it. I have 3, sage green, fde, and this is my black one after some custom paint.
With an Impact and Trigger Tech, .223, I had to remove the mag block limiter (I guess you call it that) to get the action in. The front ledge of the hanger/trigger would hit it. No issues feeding, etc. without it. I didn't take the time to see if it could be trimmed down and decided to see if it functioned without it. MDT polymer magazines.
I have 2 Accurate mags that I fiddled with ON A TIKKA CTR .223/BRAVO and may have ruined those while on the Tikka. They work also but I'm still tweaking the feedlips as a result of the Bravo aftermath.
I have 2 Accurate mags that I fiddled with ON A TIKKA CTR .223/BRAVO and may have ruined those while on the Tikka. They work also but I'm still tweaking the feedlips as a result of the Bravo aftermath.
I've been running one since December with an Origin action. I love it so far after 4 matches. It did not like MDT and 6GT. Switch to ARC mags and it's been GTG.
