Accessories AXMC/AXSR barrel cleaning screw on bore guide.

pfl338

Luv2#Steel....
Supporter
Full Member
Minuteman
  • May 16, 2020
    333
    900
    Fort Worth TX
    Own a AXMC or AXSR and use multiple barrels at a range session? Easy way to clean those barrels off the action. Screw on (M30) bore guide. Three sizes, 338,30,6.5. 3D printed using PETG. 1pc -10.00 TYD, 2pc -15.00 TYD or all 3 -20.00TYD. PayPal FF or you can mail me a check.
    IMG_1074.jpg
    IMG_1075.jpg
    IMG_1076.jpg
    IMG_1078.jpg
    IMG_1080.jpg
    IMG_1079.jpg
    IMG_1077.jpg
     
    I need a 6mm one for a m27 thread as well good sir. And probably would hurt to have a 22cal either.

    Easy solution here @Krob95 Just buy an SR and some extra barrels so you can use his m30 thread protector bore guides.




    I'll take one in 6.5, 308, and 338 In the m30

    If you can make just the standard tread protectors too, I need 12 of them. Will send PM to inquire.

    Thanks,

    Jake
     
    Easy solution here @Krob95 Just buy an SR and some extra barrels so you can use his m30 thread protector bore guides.




    I'll take one in 6.5, 308, and 338 In the m30

    If you can make just the standard tread protectors too, I need 12 of them. Will send PM to inquire.

    Thanks,

    Jake
    The day will come when I get a SR. But that day is not today 😂
     
    Received mine today

    Excellent fit and finish on my AXMC barrel. Perfect for a guide and/or just a thread protector

    Just ordered 3 more for the MC and AT barrels
     
    • Like
    Reactions: wizardpc
    Would you be making these for standard threaded barrels ? Like Impact, TL3, etc….
    If you have a need for some I can design and print a few for you. I will need you to send me a picture of the tenon ,thread size( so I can make a gage) and the actual length of the tenon. Since I will have to single point a gage, design and print, it will take a few days to get the porotype.
     
    I will take the “all three” set. Will PM now. Although only for thread protection I will not be shamed into actually cleaning any barrels!
     
    Just recieved the new guides with the solvent port. Makes cleaning the barrel (off rifle) so much easier and much less messy. No more solvents leaking out of the guide when you feed the patch through the guide hole.

    Thanks Pfl338!
     
    • Like
    Reactions: carbonbased