Barrett m82a1 scope mount
- Thread starter Larry Lambert
- Start date
For a one piece 50 BMG mount, LaRue makes the LT107 QD mount:
You would need the 34mm rings on that scope (options are 30mm, 34mm, or 35mm). It has 3 QD levers locking it in place.
You would need the 34mm rings on that scope (options are 30mm, 34mm, or 35mm). It has 3 QD levers locking it in place.
NF Mag Mount A361, it's far less expensive compared to LaRue, equal to or better than quality compared to LaRue, and it won't fuck up your rail over time like the LaRue levers do.
We're far enough into the 21st century that I believe it's been realized QD scope mounts were never that practical and it's irrational to pay $450 for early-2000's technology regardless of how much repackaged spice and paint can thingies they throw in the box. There's also a host of other options from Seekins, Hawkins Precision, Badger Ordnance, etc...mainly you're probably going to be looking for something in the 1.50" - 1.54" height range with 0 MOA since the Barrett rail already has sufficient slope built into it.
Good luck.
We're far enough into the 21st century that I believe it's been realized QD scope mounts were never that practical and it's irrational to pay $450 for early-2000's technology regardless of how much repackaged spice and paint can thingies they throw in the box. There's also a host of other options from Seekins, Hawkins Precision, Badger Ordnance, etc...mainly you're probably going to be looking for something in the 1.50" - 1.54" height range with 0 MOA since the Barrett rail already has sufficient slope built into it.
Good luck.
