I searched and didn't find enough to insure I understand what is required to successfully bed the action into this stock. As I understand, this stock has an aluminum bedding block that will require sanding to get the Devcon to adhere to it. Here are some questions:
Do I "pillar" the action? Where do I get the pillars? How do I insure the pillars are the correct length?
From what I have read, taping, applying release agents, and applying putty to all the holes is really important and I need to take my time here.
The one video I watched really loaded up the bolts and the stock with bedding material. It squeezed out everywhere. Is this really the process?
Once the bedding material is in that's it. It is either successful or the stock is toast, unless I end up gluing the action to the stock.
Any pictures or advise here would be helpful especially dealing with a Remington 700 SPS-AAC 308 in the HS Precision Remington 700 Police stock.
Thanks!!!!
Do I "pillar" the action? Where do I get the pillars? How do I insure the pillars are the correct length?
From what I have read, taping, applying release agents, and applying putty to all the holes is really important and I need to take my time here.
The one video I watched really loaded up the bolts and the stock with bedding material. It squeezed out everywhere. Is this really the process?
Once the bedding material is in that's it. It is either successful or the stock is toast, unless I end up gluing the action to the stock.
Any pictures or advise here would be helpful especially dealing with a Remington 700 SPS-AAC 308 in the HS Precision Remington 700 Police stock.
Thanks!!!!