Accessories Crown Ridge 300 RUM Remage Barrel

[TicTacTex]

Thought I was going to put a RUM together, but need to free up some funds for something else.
26” Crown Ridge carbon fiber, 10 twist, 5R, with a remage nut, muzzle threaded 5/8-24.
Bought it lightly used, has no more than 300 rounds on it. Not sure who did the barrel work.

$500 shipped. PM me first, I will not PM you. Anyone else is a scammer.

 

[TicTacTex]

^^^^^^^^ Make an offer.

 

[The Reloader]

what is the counterbore? Standard Remington 700 of 0.705"?

 

[TicTacTex]

what is the counterbore? Standard Remington 700 of 0.705"?

I don’t know, but I could measure for you later. I am not the original owner, nor do I know who cut the chamber.

 

[supercorndogs]

My exeperince with Crown ridge barrel works has been very good. I just need another magnum caliber barrel like I need a hole in the head.

 

[TicTacTex]

what is the counterbore? Standard Remington 700 of 0.705"?

I measured right at 0.3xx”, so doesn’t look like this will work with a Remington 700.

I assume we’re on the same page, and you’re asking about the depth before the chamber begins to allow clearance for the bolt nose?

 

[The Reloader]

No. The counterbore diameter. This is the diameter where the bolt goes into barrel just a bit. Those with M16 and Sako extractors need more than the standard .705" counterbore.

 

[TicTacTex]

No. The counterbore diameter. This is the diameter where the bolt goes into barrel just a bit. Those with M16 and Sako extractors need more than the standard .705" counterbore.

Ah, major brain fart. Have no idea why I was thinking depth.
I’ll get back with you.

 

[TicTacTex]

No. The counterbore diameter. This is the diameter where the bolt goes into barrel just a bit. Those with M16 and Sako extractors need more than the standard .705" counterbore.

Confirmed it is 0.705”.

 

[TicTacTex]

Need it gone.