A little over 17 months ago I bought a DPMS Oricle LR-308... disliking the factory stock I swapped it out quick for UBR I had on hand and a brake
Ugly duck
shot some lack luster groups and struggled to keep it under 2 MOA at 100 yards
After building a few others AR's over the last year I decided to go back to this rifle and see if I could squeeze anymore from her. Added a Troy forearm, Geissele trigger, YHM clamp on gas block replacing the set screw gas block, a different brake and an old A2 stock.
Here are Mondays results at 100y using IMI brass & AR-Comp and 168 A-Max 2nds, this brass has about 1.5 grains less water volume than Lapua brass.
I started at 37.9 and ended with 39.5
The first and last swelled to MOA+ but the other three are between .57-.85 CTC
I'm impressed, I decided to test between 38.2-38.8 in 2/10th of a grain and let the magnetospeed select the load.
Tuesday, after checking velocity I think the load I'll use is 38.6 AR-Comp in IMI brass under a 168 amax at 2.805" good numbers and grouped well. The numbers:
38.2 2361 5/14
38.4 2367 9/23
38.6 2378 5/12
38.8 2395 7/19
I also shot five IMI 175 Razor core at 300 (3.25") and 500 (5.75) not bad for a 8x optic with a lot of parallax.
Hope to add some groups on steel at distance in the coming days
The point of all of this is Maybe DPMS barrels can shoot
Ugly duck
shot some lack luster groups and struggled to keep it under 2 MOA at 100 yards
After building a few others AR's over the last year I decided to go back to this rifle and see if I could squeeze anymore from her. Added a Troy forearm, Geissele trigger, YHM clamp on gas block replacing the set screw gas block, a different brake and an old A2 stock.
Here are Mondays results at 100y using IMI brass & AR-Comp and 168 A-Max 2nds, this brass has about 1.5 grains less water volume than Lapua brass.
I started at 37.9 and ended with 39.5
The first and last swelled to MOA+ but the other three are between .57-.85 CTC
I'm impressed, I decided to test between 38.2-38.8 in 2/10th of a grain and let the magnetospeed select the load.
Tuesday, after checking velocity I think the load I'll use is 38.6 AR-Comp in IMI brass under a 168 amax at 2.805" good numbers and grouped well. The numbers:
38.2 2361 5/14
38.4 2367 9/23
38.6 2378 5/12
38.8 2395 7/19
I also shot five IMI 175 Razor core at 300 (3.25") and 500 (5.75) not bad for a 8x optic with a lot of parallax.
Hope to add some groups on steel at distance in the coming days
The point of all of this is Maybe DPMS barrels can shoot