Re: Finally finished my TRG...
<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Dutch405</div><div class="ubbcode-body"><div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: palmik</div><div class="ubbcode-body"><div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Dutch405</div><div class="ubbcode-body">Ok thanks Bacarrat, I actually am planning on doing the same thing. My TRG is a 26" so I just went ahead and ordered a cyclone in 5/8x24 with the thought of cutting my barrel down to 20. Originally I was wanting to cut the barrel and keep the same thread pitch so I could swap back and forth between my cyclone and my Sako muzzle brake, but after having the difficulty in finding a cyclone in m18x1 I went the other route.
Also Bacarrat, if you don't mind me asking, who are you going to have cut your TRG barrel? A couple of local gunsmiths have been hesitant to cut my barrel because they heard that removing the barrel from the TRG action is slightly difficult and they don't want to mess anything up.
thanks for the help!</div></div>
Mark Gordon at short action customs can cut your barrel down. </div></div>
Hey Palmik,
Thanks for the recommendation! Have you seen alot of Marks work? From looking at his website, it looks like I may have just found someone to do my barrel work. Thanks again!</div></div>
Mark is a good friend of mine, has done work for me, and yes, I have seen dozens of rifles he has done. He is one of the few guys out there that doesn't cut any corners, no exceptions. He will take care of you.
