Gunsmithing Flush cups on a carbon fiber stock

[tinytigers]

I'm looking to put flush cups in a Proof Tac 2 stock. I've reached out to Proof and they say they won't do it, but I was wondering if anyone with experience could weigh in on installing flush cups into a carbon fiber stock, or if it could be done by a gunsmith.

Thanks,
Jeff

 

[chutinlead]

It wasn't in a carbon fiber stock and I have access to a Bridgeport mill and do all my own gunsmithing, but I installed flush cups on both the front and rear of a boyds stock I had on my hunting rifle for this year.

I wanted them to be the rotation limited kind and found this guy selling them on ARFCOM

AR Accessories & Misc > AR15.COM

Firearm Discussion and Resources from AR-15, AK-47, Handguns and more! Buy, Sell, and Trade your Firearms and Gear.

www.ar15.com

I think unless it was hollow or had voids somehow thru the stock, you should be able to have some installed. Rather than press fit, I might go a tad oversize and epoxy them in so it doesn't crack on ya.

 

[Maurygold]

yes it can be done. contact chad at LRI for any gunsmithing needs and he will get you fixed up

 

[tinytigers]

yes it can be done. contact chad at LRI for any gunsmithing needs and he will get you fixed up

Awesome! Will do, thanks!

 

[xdeano]

Grovtec threaded flush cups. Just drill the correct size hole, tap said hole, epoxy hole and screw them into place.

Devcon10110 works well. So does the gorilla glue clear epoxy.

Xdeano