For KRG BRAVO owners

[Blue72]

Can you tell me how hard it is to remove the back half of the stock. I like to fit my rifle in a smaller discreet travel case and I know the bravo grip/shoulder stock is removable. But I would like to know how involved it is and if it’s solid enough to deal with this being done several times

 

[Bandit31]

You’d need to remove the rear action screw and a screw on top of the chassis behind the tang to take off the rear half of the Bravo. Depending on your optic and ring height, it may prove difficult to access the top screw to remove it requiring you to unmount your scope every single time.

 

[Blue72]

You’d need to remove the rear action screw and a screw on top of the chassis behind the tang to take off the rear half of the Bravo. Depending on your optic and ring height, it may prove difficult to access the top screw to remove it requiring you to unmount your scope every single time.

Thank you, much appreciated

I guess I will look at other options

 

[rickdavis81]

With a regular Allen wrench you shouldn’t have an issue removing the top screw with optic in place.

 

[Blue72]

With a regular Allen wrench you shouldn’t have an issue removing the top screw with optic in place.

I just not sure if I constantly want to unassemble and assemble the action screws when traveling to the range. I might consider a folding stock or just use a regular case

Even though I really like the bravo stock

 

[rickdavis81]

Probably your best bet and the route I’d go

 

[chevy_man]

A normal case would by far be the cheapest and easiest option.