Based upon other thread comments, we might need a thread on Fixing Gas Cans...
This is an interesting solution.
<iframe width="560" height="315" src="" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe>
I have used the Schrader valve and coat hanger technique- remove the valve stem core and use the screw on cap as the vent-
Drill the hole off center- not on the seam
This is an interesting solution.
<iframe width="560" height="315" src="" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe>
I have used the Schrader valve and coat hanger technique- remove the valve stem core and use the screw on cap as the vent-
Drill the hole off center- not on the seam