I've had really good luck with Vihtavuori N555 in my 6.5 Creedmoor. This is three shots @ 200 yards. 2760 fps 136 grain Lapua Scenar L.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
To enter, all you need to do is add an image of yourself at the range below! Subscribers get more entries, check out the plans below for a better chance of winning!
Join the contest SubscribeNice! How much powder to obtain this MV, and what brass are you using? Barrel length, twist?This is three shots @ 200 yards. 2760 fps 136 grain Lapua Scenar L.
43.4 grains, Lapua SRP brass, CCI450, 26 inch 1:8 twist barrel.Nice! How much powder to obtain this MV, and what brass are you using? Barrel length, twist?
Great, thanks. I started shooting and reloading for 6.5CM this year...also using N555 with similar MV as you, and satisfactory results (for me) downrange...I use 43.0 gr, Lapua LRP, CCI 200...sending 140 gr pills out of a 26"-1:8 tw barrel43.4 grains, Lapua SRP brass, CCI450, 26 inch 1:8 twist barrel.
I've found that my rifle shoots better with slightly compressed loads and SRP brass. I don't mind sacrificing a few grains of powder for repeated precision.I loved how it shot I was just not a fan of how much more powder I needed to use than other brands to get the same speeds 40.8 gr of h100v to get about the same speeds as 43.6 gr of n555 around that 2750's + or - 20fps speed wtih a 140 gr projectile or 41.3gr of rl17 or 41.8gr of h4350
I did the same thing.I purchased 8lbs yesterday. My vendor said Capstone is raising prices on all their products before end on this year.
N555 is my powder of choice for 6.5 creedmoor. Use 142 smk but will have some scenar-l 136 next week to work up.I'm using 43.5gr of N555 with Lapua SRP (CCI #400), Lapua Scenar-L 136gr, COAL 2.854, with great results. I've shots multiple 0.7moa group at 300 meters with a Tikka T3x CTR, factory barrel. Basically, I love the powder, it's very clean and got greats results at very varying temperatures.
If you have some load data for the smks to shareN555 is my powder of choice for 6.5 creedmoor. Use 142 smk but will have some scenar-l 136 next week to work up.
I use 41.6gr n555, lapua lrp brass, fed gmm at ~2.8 coal. Avg velocity is 2715. The 142 smk are hard to find. I also have the 140 smk but better groups with the 142.If you have some load data for the smks to share. The Scenar-L have been hard to get since a few months here, there is 136/139 that pop up in small quantities from time to time though. N555 is always in stock, go figure.
I don't have the measurement anymore, sorry. I used the 'old' tricks of using a dummy cartridge with a projectile seated by hand. Got a rather long seating depth, over max OAL. Loaded some rounds, but didn't notice major improvements in group sizes. Later, in went back to 2.854 for the 136gr Scenar-l. Maybe I should invest in a Lock-N-Load® O.A.L. Gauges.Nice group. How far off the lands?