hollow point driller

[seanh]

Anyone have a link to a hollow point driller? Ed Brown used to make one but it has been discontinued. I've done some searching and they seem to have vanished.

I did find one DIY hollow pointer but that's about it.

 

[TOP PREDATOR]

i did this with the PACO tool:

http://www.snipershide.com/shooting...7-paco-kelly-acurzr-resizing-tool-review.html

produced very nice hollowpoints, but ammo wasn't as accurate at further distances compared as to before the modification.

i hear good things about the neal waltz die, however i haven't followed up yet with getting one.

 

[OnyxSkyDV]

I remember something called a paco tool that would let you form the nose of live .22lr ammo, might look for that.

Onyx

(Ha! beat by seconds, and with a link, well played Top)

 

[TOP PREDATOR]

^ just lucky. with the switch of the site, getting links aren't is quick as they used to be

i'm now thinking that with the new lines of CCI hollowpoints, segmented, quiet segmented, etc. VS. the amount of time to make your own, i'd rather just buy them off the shelf - if you can find any on the shelf.

 

[seanh]

I've seen the Paco tool...may consider it but don't care for punch method. What I'm hoping to find is something that I could drill a hollow point and set the depth like the E A Brown tool. I'm wanting to drill a bunch of round nose and test diameter/depth for varmint control.

A couple bullets I'd like to test is the Super Colibri and cb longs

 

[Ron Suttle]

Neal Waltz makes these dies. I have had them for a while, and I don’t know if they are still available. I think I paid $125.00

Neal Waltz Dies | Flickr - Photo Sharing!
Neal Waltz
4105 Hyatt NW
Massillon, OH 44646-1435
Phone - 1 330 837 4818

 

[Gary Paugh]

sportsmans guide has them.

 

[seanh]

Thanks...I'll probably get the one at sportsmans.

Too bad I don't have access to a lathe anymore...it's an easy tool to make.

 

[repiv]

can someone post a link to the Neal Waltz die at Sportsmans?